Door, Door Glass & Parts

The Lid Assembly is an OEM part for GE washing machines. This part is the lid of the washer. It is essential for securely covering the washer drum, preventing water from splashing out during the wash cycle, and allowing safe operation by ensuring the washer does not run with the lid open.

Causes of a bad lid assembly can include general wear and tear, physical damage from heavy loads or impacts, or issues with the hinges or latch mechanisms.

Symptoms of a bad lid assembly include:

• Difficulty in opening or closing the lid
• Washer not starting or stopping mid-cycle due to a faulty lid switch
• Visible cracks or damage on the lid
• Water leaking from the top of the washer

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Restore a clear, safe view into your oven with this door glass. It replaces a damaged or discolored window so you can monitor cooking and helps the door seal and look like new again.

• Forms the viewing window in the oven door
• Helps contain heat and support normal oven performance
• Restores clear visibility into the oven cavity
• Typical failure signs: cracked/shattered glass, loose or rattling window, severe staining or haze

• Disconnect power and allow the appliance to cool completely before starting
• Remove the door per your model's instructions and work on a padded, stable surface
• Handle glass with cut-resistant gloves; avoid flexing or striking edges
• Transfer and reuse original screws, brackets, and trim as required; tighten fasteners evenly without overtightening

The Frame is an OEM part for Frigidaire washing machines. This part provides support and structure for the inner door components, ensuring a secure and tight seal during washing cycles to prevent leaks and maintain efficient operation.

Causes of a bad inner door frame can include wear and tear from regular use, physical damage from accidental impacts, or warping from exposure to high temperatures or moisture. 

Symptoms of a bad washer inner door frame include:

• Leaking water during wash cycles
• Difficulty closing or latching the door
• Visible cracks or warping on the frame
• Unusual noises during operation

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

The Glass Oven Door Outer Trim is an OEM part for GE ranges. It provides a protective and decorative frame for the outer glass panel of the oven door. This trim helps to secure the glass in place while also contributing to the overall aesthetic of the appliance.

Causes of a bad outer trim can include wear and tear from regular use, accidental impacts that cause cracks or chips, or exposure to high temperatures that can lead to warping or discoloration.  

Symptoms of a bad Glass Oven Door Outer Trim include:

• Visible cracks or chips in the trim
• The trim becoming loose or detached from the door
• Discoloration or warping of the trim
• Difficulty in securely closing the oven door

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

The Window Pack Assembly is an OEM part for GE ranges. This part allows you to monitor your food while it cooks without opening the door and letting heat escape. The assembly ensures clear visibility and helps maintain the oven's internal temperature for consistent cooking results.

Causes of a bad window pack can include accidental impacts, thermal stress from repeated heating and cooling cycles, or manufacturing defects.  

Symptoms of a bad window pack assembly include:

• Cracks or breaks in the glass
• Fogging or condensation between the glass layers
• Difficulty in seeing through the window
• Heat escaping from the door area

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

The GE Glass Oven Door is an OEM part for GE ranges. It allows for viewing of dishes inside the oven cavity without opening the door.

Symptoms of a bad glass oven door include:

• Cracks or chips in the glass surface reduce structural integrity  
• Inability to form a proper seal around the oven chamber when closed
• Leaks or drafts felt around the door seal during baking 

Causes of a bad glass oven door may include normal wear and tear over years of heating and cooling cycles. Exposure to cleaning chemicals could potentially erode seals prematurely as well.

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Note: Per factory, the glass no longer has the foil tape.

The Outer Door Glass is an OEM part for Frigidaire ranges. As the outermost barrier protecting the interior of the oven, the door glass is subject to wear, scratches, and impact damage through regular use. Made of durable heat-resistant tempered glass, this OEM replacement part ensures your oven door retains its integrity.

Causes of a bad door glass can include small chips or cracks that develop from regular cleaning or use over time. Larger cracks or breaks are often caused by impact or mishandling.

Symptoms of a bad door glass include:

• Cracks or chips that compromise the structural integrity of the glass
• Increased heat loss from the oven when in use
• Inability to properly seal the oven door
• Possible injury risks from broken or damaged glass

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This is the inner door frame assembly for a microwave oven. It provides the structural support for the door's window, trim, handle, and latch so the door aligns and closes properly and the interlock switches engage.

• Forms the inner structure of the microwave door and supports the window/screen, trim, and latch components
• Helps maintain alignment so the door closes and latches securely
• Replace if cracked, warped, or if mounting tabs are broken
• Typical symptoms include a door that won't close or stay shut, "door" error messages, the unit not starting unless the door is pressed, or a loose/rattling door panel

• Disconnect power before servicing; if over-the-range, support or remove the microwave before working on the door
• Use gloves/eye protection and watch for sharp edges
• Photograph door stack-up; transfer existing glass, handle, choke/trim, hinges, and screws to the new frame
• After reassembly, ensure the door closes squarely and that interlock switches engage before restoring power

Color: White

Color: White

This replacement oven door glass restores a clear viewing window and proper heat retention. Replace this pane when the glass is cracked, shattered, or permanently stained to keep your oven safe, efficient, and easy to monitor.

• Forms the inner or outer window of the oven door, sealing heat while letting you watch cooking progress
• Helps maintain temperature stability and preheat performance
• Common failure signs: visible cracks or chips, shattered glass, fogging or residue between panes, or difficulty maintaining temperature
• Restores safety by eliminating sharp edges and reducing risk of further breakage

• Disconnect power and allow the oven to cool completely; shut off gas supply if applicable
• Wear cut-resistant gloves and eye protection; handle glass carefully
• Remove the door and glass retainers; note screw and trim orientation
• Transfer any clips/trim from the original pane as needed; reassemble without overtightening and confirm door alignment and seal

The Lid Assembly is an OEM replacement part for LG washing machines. It is the top cover that provides access to the washer's tub, allowing users to load and unload laundry items.

Symptoms of a faulty washer lid assembly include:

• Difficulty opening or closing the lid
• The lid not fitting securely or sealing properly
• Cracks, dents, or other visible damage to the lid structure

Causes of a bad lid assembly can stem from physical impact or mishandling, excessive force when opening or closing, warping due to heat exposure, or simply normal wear and tear over extended use.

This OEM LG part is also compatible with applicable Sears/Kenmore washer models. 

This inner door frame forms the interior half of the appliance door. It holds the window and mounting points so the door aligns and latches correctly, replacing cracked or warped plastic that can affect closing performance.

• Forms the interior structure of the door and supports the window
• Provides mounting locations for hinge, strike/catch, screws, and trim
• Helps maintain proper door alignment and seal contact when closed
• Damage can cause misalignment, difficulty latching, rattling/loose window, or a door that won't stay shut

• Disconnect power; if servicing a washer, also turn off the water supply
• Remove the door, place it on a padded surface, and transfer the window and any door hardware to the new frame
• Reuse existing fasteners; tighten evenly and avoid overtightening into plastic
• Verify the door closes and latches smoothly before returning the appliance to service

The Door Glass is an OEM replacement part for Whirlpool ranges. It provides insulation and protection for the oven cavity and maintains the proper temperature inside the oven while allowing you to visually check on your dishes without opening the door.

Symptoms of a faulty inner door glass include:

• Cracks or shattered glass
• Foggy or discolored appearance
• Heat escaping from the oven

A bad inner door glass can occur due to accidental damage, extreme temperatures, or regular wear and tear. If you notice signs such as cracks, shattered glass, or foggy appearance, it may be time to replace the inner door glass.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.
 

The Microwave Glass Door is an OEM part for Whirlpool brand microwaves. This stainless door acts as a protective barrier that covers the cooking cavity while allowing for the transmission of microwave energy through its glass pane. 

Causes of a bad glass door include impact damage, excessive heat exposure over time, or failure of door hinges and mechanisms due to regular use wear, and tear.

Symptoms of a bad glass door include:

• Cracks or chips in the glass pane 
• Difficulty closing or latching the door securely
• Warping or discoloration of the door frame or seal

This OEM Whirlpool replacement part is compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and select Kenmore models.

Restore safety and appearance with this black oven door glass panel. It replaces cracked or shattered glass, bringing back a clear viewing window and the original finish when the exterior door glass has been damaged.

• Replaces damaged door glass to restore visibility and appearance
• Helps keep the door assembly secure when installed correctly
• Common symptoms: visible cracks, shattered/spidered glass, loose or rattling panel, cosmetic damage
• Color/finish: black

• Disconnect power and let the oven cool completely before starting
• Remove the door per your manual and place it on a padded surface
• Wear cut-resistant gloves and eye protection; handle tempered glass carefully
• Transfer any handle/trim as required and reinstall without overtightening fasteners