General Electric Tub Ring Or Cover, Counterweight

Note: Newly designed cover includes 4 new rod and spring assemblies. The tub dampening straps and clips are no longer used.

Restore a proper seal at the top of your washer's tub with this tub cover assembly. It contains water and suds, reduces splashing, and provides a smooth rim to protect garments during wash and spin. Also called a tub ring.

• Seals the top of the outer tub to keep water and suds contained during operation
• Provides a smooth basket opening to help prevent fabric snagging
• Helps maintain stable operation; a cracked or loose cover can rub, vibrate, or leak
• Common symptoms: water or suds at the top of the tub, excessive splashing, visible cracks or broken tabs

• Disconnect power and turn off water supply before servicing
• Lift/remove the washer top to access the tub area; release clips/fasteners holding the old cover
• Clean the tub lip and transfer any reusable components from the old cover if applicable
• Seat the new cover evenly and secure all tabs/clamps; run a leak check

This rear counterweight helps restore proper balance to the appliance door or panel so it opens and closes smoothly and stays in position during use. It's a direct-fit replacement designed to match the original component. What it does:

• Balances the door/panel to reduce sagging and uneven movement
• Restores smooth opening and closing motion
• Helps stop unwanted rattling or shifting during operation
• Works with the original bracket and fasteners to maintain correct alignment

• Disconnect power (and water if applicable) before beginning service
• Support the door or panel while removing the old counterweight to prevent drop or injury
• Remove and reuse factory fasteners unless replacements are provided; tighten securely to OEM torque

Hose is not required. Kit includes bleach funnel, clamps, wire tie, and cap.

A right-side counter weight that restores proper door balance and alignment for compatible refrigeration units. Replaces a worn or missing weight to help doors open, close and stay aligned as designed. What it does:

• Balances the door to prevent sagging or uneven gaps
• Helps the door close fully and maintain a consistent seal
• Restores smooth, predictable door movement after weight loss or damage
• Works with the factory mounting locations and fastening method

• Install with power off and empty door storage to reduce strain and risk
• Use the factory mounting hardware and torque to manufacturer guidance
• Check door alignment and seal after install; adjust hinges if needed
• If the weight or hardware is damaged, replace both for best alignment

This front/bottom counterweight stabilizes and balances the appliance door, helping maintain proper alignment for smooth opening and closing. It replaces a worn or missing weight to reduce door sag and improve fit. What it does:

• Balances the door to prevent sagging and uneven gaps
• Helps the door close securely and stay aligned
• Reduces rubbing or scraping at the hinge area
• Restores proper door feel and reduces noisy operation

• Disconnect power to the appliance and remove any contents from the door before beginning
• Installation may require removing the door trim or accessing the lower hinge area; keep all fasteners
• Handle the weight carefully to avoid pinching fingers; use proper tools and support the door during reassembly

This outer tub cover protects the washer's tub assembly and helps contain water while keeping internal components free from debris. Replacing a worn or damaged cover restores a secure seal and helps reduce unusual noises or leaking. What it does:

• Covers and protects the washer tub assembly from debris and wear
• Helps maintain a proper seal to contain water during wash cycles
• Prevents contact between the spinning tub and cabinet components
• Can reduce banging or rubbing noises caused by a damaged cover

• One outer tub cover

• Disconnect power and water before starting any repair
• Remove washer cabinet or access panels to reach the tub cover
• Handle part carefully to avoid damaging mounting tabs; use proper fasteners shown in the OEM guide