Need Help?
Call or text
Refrigerator clicking but not cooling? A failed overload protector can prevent compressor startup. This part interrupts power during overheating.
Usually ships within 4 - 14 days
Compressor won't start or kicks out after trying? This overload protector prevents motor damage. DIY-friendly repair, takes about 30 minutes to replace.
I read alot of blogs about the same similar symptom, but none described by exact problem. I kept reading how the compressor relay would make a click noise or sisal. I also found out the overload switch could cause a like symptom. The end result being that upon removal of the relay, it was discolored and made a rattling noise when shook. The overload switch was heat cracked on the plastic and looked like it had had enough. This was easily accomplished by using the repair mans print out for the... Read more
Refrigerator won't cool and compressor just clicks or hums? The start relay helps the compressor motor start. Moderate DIY repair, clean coils first.
I researched the problem and determined that the only thing that can cause this was compressor bad or not starting. Since it was cold the day before I felt it had to be the starter parts and ordered them. It was also very important to clean the coil which I believe caused the over heating. Read more
This evaporator fan blade mounts on the fan motor and circulates cold air across the evaporator coils and throughout the compartments. Replacing a cracked, warped, or loose blade restores proper airflow and stable temperatures.
Ordered a new fan. Read more
Refrigerator won't start or clicks repeatedly? A faulty PTC relay prevents the compressor motor from starting. This start device restores operation.
Refrigerator clicking but not cooling? A failed compressor overload protector prevents the compressor from starting. This part restores normal operation.
This was easier then I made it. Originally took the actual ice maker out without removing the whole system from the door. There are 3 silver screws that do that hold the whole mechanism in place, as opposed to the 5 white screws that hold the ice maker in place. With the entire assembly out it was a matter of routing the ground wire, retaping the wires, and then the whole assembly went back into the door without a problem. Need a phillips and a flat screwdriver, I also found a needle nose... Read more
Guardette (right) is a replacement right-side protective guard used on select GE refrigerators. It restores the interior guard/trim that protects components and helps keep the cabinet interior aligned for smooth door and shelf operation. What it does:
Fix a refrigerator that won't cool or runs constantly with this compressor start relay. Simple replacement takes 15-30 minutes with basic hand tools.
Refrigerator not cooling or compressor not starting? This overload protector prevents compressor failure by stopping excessive current draw. DIY repair.
Freezer not cooling or compressor won't start? This compressor control module manages start/stop functions to restore proper cooling performance.
Refrigerator won't start or compressor overheats? This overload protector interrupts current to prevent motor damage and restore reliable operation.
Fix a refrigerator that won't cool or cycles on and off frequently with this compressor overload protector. Protects motor from damage. DIY-friendly repair.
Refrigerator won't start or compressor shuts off? This overload protector defends the compressor from electrical damage. Simple plug-in installation.
Freezer not cooling or won't start? This compressor control module regulates start/stop cycles to restore proper cooling. Moderate difficulty repair.