Screws, Nuts, Washers

Replaced old lock and installed replacement lock and now have a happy wife. Read more

I replaced the transformer. Did not fix the problem and the new transformer overheated and failed as well. Your support person suggested the ignition module is bad. I bought a new igniter box and you replaced the transformer. The transformer got hot with only the harness connected. I found a short in one of the switches. I bought the harness, connected everything and it worked Read more

I replaced the transmission, and a few other parts associated with the transmission. Read more

Disassembled and replaced ac motor. The hardest part was to pull the microwave out of the cabinet. Read more

After receiving the part, I found I had to dismantle the left side of the handle in order to fix the right side that was broken. When I took the left side of the handle off I found the plastic piece that broke on the right side was about to break on the left side also. Having all the details and in advance of another broken handle, I ordered the part, just to have when it breaks. Read more

I opted to save myself about $600 by repairing my 8 year old LG washing machine rather than buying a new one. After watching some videos I determined what I needed upon taking my washing machine apart. I ended up replacing the tub (includes spider and shaft), since I could not get the spider part removed from the original tub, as well as the motor bolt (which had broken when I removed it from the original tub's shaft). The spider was cracked and the shaft was wobbling which caused it to... Read more

I replaced the keypad entry and it fixed the problem for 24 hours, but then it beeped and entered 0. But is much better than it was. I am an electronics tech and I know through the yrs 2000-2010 there were a rash of bad capacitors produced. I now believe a second board which has these capacitors is the source of the problem. I also believe the second board let voltage spikes through which slowly damaged the keypad board. My goal is to order the capacitors which cost less than a $1 each... Read more

I positioned the element under the top of the stove and placed it back in there with the bracket and screw. Turned out perfectly. Read more

Replaced front dryer drum support and lint trap duct as both were disintegrating with multiple cracks. While not as easy for me as in the videos, as placement required a little more jostling of the parts to place and fit snugly, the videos were amazingly helpful and I would never have accomplished the repair without them. I used a Phillips head and a screwdriver. Great experience dealing with customer service as well, as 2 extra wires were sent with the lint trap assembly which my older model... Read more

You sent us the correct kit and my husband fixed it. Read more

New parts were correct and easy to install. Read more