Washer Motor

The Fan Motor Assembly is an OEM part for LG washing machines. It powers the fan responsible for circulating air and venting moisture from the washer drum during the drying cycle. 

Causes of a faulty fan motor assembly can stem from various factors. These include motor bearing wear due to prolonged use, electrical faults or winding issues within the motor, and physical damage or obstructions that hinder proper fan rotation.

Symptoms of a bad fan motor assembly include:

• Inadequate or no airflow during the drying cycle
• Excessive moisture buildup or poor drying performance
• Loud grinding, squeaking, or rattling noises from the fan area

This OEM LG part is also compatible with some Kenmore models.

This induction motor assembly powers the mechanical drive in compatible laundry appliances, restoring rotation for tumbling or airflow so the appliance can resume normal operation. Designed to replace a worn or failed motor quickly. What it does:

• Drives the appliance's mechanical components to enable drum tumbling or blower rotation
• Stops functioning when the motor is worn, causing no tumble, humming, or intermittent operation
• Restores reliable rotation when the original motor has seized, failed to start, or runs inconsistently
• Works as the direct replacement motor specified for the listed part number

• Disconnect power before beginning any repair to avoid shock or injury
• Installation may require basic hand tools and removal of access panels
• Inspect wiring and mounts for damage and replace any worn fasteners or wire connectors

This motor assembly kit replaces a worn or failed motor assembly to restore proper operation, reduce noise and vibration, and get the appliance running reliably again. Designed as a direct-replacement assembly. What it does

• Drives the appliance's rotating components so drums, tubs, or blowers spin as intended.
• Helps eliminate failure symptoms like a unit that won't start, won't spin, or only hums.
• Reduces abnormal noises, grinding, or excessive vibration caused by a failing motor.
• Restores normal airflow or agitation when a motor-related fault reduces performance.

• Disconnect power (unplug or flip breaker) before starting any repair.
• Basic hand tools and moderate mechanical skill are typically required; follow factory service instructions.
• Keep wiring orientation and mounting hardware correct; replace any damaged clips or fasteners.

This motor inverter and control kit is the assembled replacement for a failed motor inverter/control module, restoring proper motor speed control and electronic drive functions so the appliance can run reliably again. What it does:

• Replaces the inverter and motor control electronics that govern variable motor speed and start/stop functions
• Restores normal motor operation when the inverter or control has failed or produced drive errors
• Can resolve symptoms like the motor not starting, intermittent operation, or electronic error/fault codes
• Helps eliminate abnormal motor behavior caused by faulty control electronics

• Disconnect power to the appliance before starting work to avoid shock or injury
• Handle the control board and connectors by the edges; avoid touching circuit traces and components
• Use common hand tools and follow the appliance service manual for removal and installation steps

This genuine OEM part is a drive motor for washers. The drive motor is the main engine that drives the washer tub allowing it to rotate and wash clothes effectively. If the washer is no longer spinning or the power has significantly decreased, it might be a sign that the drive motor needs to be replaced. Luckily, replacing this part is a relatively simple repair.To replace the drive motor, start by unplugging the washer. Once unplugged, move the washer away from the wall to gain access to the back panel. Uninstall the back panel by removing the screws that attach it. After removal, locate the drive motor and proceed to unthread the mounting screws holding it to the washer. Proceed to pull the old motor out of its place and install the new motor by threading the screws that secure it. This replacement part is sold individually and is compatible with GE, RCA, and Hotpoint brand washers.