Handle

The Frigidaire handle and latch assembly is an OEM replacement part responsible for securing and latching the dishwasher door when it is closed for a wash cycle. This part is typically located on the front panel of the dishwasher, near the top of the door. It ensures that the dishwasher door remains securely closed during operation, preventing water and steam from escaping the interior.

Causes of a bad handle and latch assembly can include repeated use leading to wear and tear, accidental damage from forceful closing or opening, or internal mechanical failures. If the assembly is compromised, the dishwasher may not start, or it could leak during cycles.

Symptoms of a bad handle and latch assembly include:

• Difficulty in opening or closing the dishwasher door
• The door not latching properly
• The dishwasher not starting or pausing mid-cycle
• Water leakage from the door during operation

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Replace a worn or broken fresh food door handle with this color-matched bisque handle to restore a solid, comfortable grip and clean appearance on your refrigerator's main compartment door.

• Provides the handhold to open and close the fresh food door
• Worn, loose, cracked, or missing handle can make the door hard to open and detract from appearance
• Color: Bisque, for models that use a bisque fresh food handle
• Restores proper feel and operation when opening the refrigerator section

• Unplug the appliance or disconnect power before servicing
• Open the door to access handle screws; support the handle as you remove fasteners
• Transfer any end caps or mounting screws from the old handle if your model reuses them
• Tighten all screws securely and check for firm, wobble-free fit

This freezer door handle assembly replaces a damaged or loose handle and restores a secure, comfortable grip. Finished in bisque to match your appliance, it refreshes appearance and helps the door open and close as intended.

• Provides the exterior grip for opening and closing the freezer door
• Attaches to the door's factory mounting posts/brackets and secures with screws or set screws (varies by model)
• Restores original look with a matching bisque finish
• Common symptoms: cracked, broken, or missing handle; handle feels loose or will not stay tight

• Wear gloves and keep the door closed for stability during replacement
• If present, remove trim caps; loosen set screws or mounting hardware and lift off the old handle
• Position the new handle on the mounting posts/brackets; tighten hardware until snug; reinstall caps
• Do not overtighten; verify the handle is aligned and secure before use

This replacement latch secures the door closed so the appliance can operate correctly. Restores a positive close and consistent door recognition to help prevent no-starts and intermittent operation. What it does / common symptoms:

• Engages the strike to hold the door/panel closed
• Ensures the door-closed signal is made so controls can run
• Worn or broken latch may cause the door not to stay shut
• Unit may not start, show a "door" message, or stop if the door is bumped

• 1 latch

• Disconnect power before servicing; turn off water supply if applicable
• Access the latch per model—typically behind the front panel or inner door liner
• Note and transfer any springs/clips from the original latch to the new one
• Verify smooth open/close and proper strike engagement before testing operation

Color: Black
 

Color: Bisque

This small handle assembly replaces a worn or broken appliance door handle to restore a secure grip and normal door operation. It's a direct-fit replacement designed for fast cosmetic and functional repair. What it does:

• Replaces a damaged or cracked small handle to stop slipping and improve door access
• Restores proper leverage for opening and closing the appliance door
• Matches the original fit and mounting points for a straightforward swap
• Helps eliminate rattling or movement caused by a loose or broken handle

• Basic hand tools typically required;
• Disconnect power and empty the door/drawer before beginning work for safety and easier handling
• Keep mounting screws and trim in a safe place and compare the new part to the old one before installing

Color: Bisque

Color: Bisque

This genuine-style refrigerator door handle provides a secure grip for opening and closing the fridge door and restores the appliance's appearance after a broken or worn handle. Durable finish matches common Whirlpool styling. What it does:

• Replaces a damaged, cracked or loose refrigerator door handle to restore proper door operation and appearance
• Provides a comfortable, sure hand grip for opening and closing the door
• Helps prevent further cabinet or door damage caused by using a compromised handle
• Fits the OEM mounting points for a clean, factory-like fit

• Use basic hand tools; disconnect power only if panels or lighting need removal for access
• Support the door while removing/installing to avoid strain on hinges or other components
• Keep fasteners and trim pieces organized to ensure correct reassembly
• Replace any damaged clips or screws with OEM parts to ensure secure mounting