Chassis Or Cabinet

Metal trim panel that mounts above the dishwasher door under the control console. Replace when original is dented, scratched, rusted, or damaged.

Base cover assembly for dishwashers. Installs at the bottom to protect internal components. Replace if cracked, damaged, or missing for proper coverage.

Base rail for electric ranges. Structural support component that mounts at the bottom of the range chassis. Replace if cracked, bent, or damaged.

Reflector pan sits under the bake element in your electric range oven cavity. Replace if cracked, warped, or rusted to restore proper heat direction.

Replace your range's back cover panel if it's cracked, dented, or missing. This protective panel installs on the rear of your electric range cabinet.

Replacement base plate for your microwave. Structural component that supports internal parts. Replace if cracked, warped, damaged, or missing.

Base plate assembly for microwaves. Mounts to the bottom of the cabinet to provide structural support. Replace if cracked, warped, or damaged.

Protects insulation at the bottom of your range. Replace this guard if it's cracked, broken, or missing to maintain proper heat insulation and safety.

Rear chassis panel for ovens. Supports internal components and protects wiring. Replace if your panel is cracked, corroded, damaged, or missing.

Replacement frame for range hood models. Installs as the main structural support housing. Order a new frame if yours is cracked, bent, or damaged.

This outer front panel replaces a damaged or dented cabinet front to restore the appliance's appearance and provide support for the door and front-mounted components. Durable sheet-metal construction keeps internal parts protected. What it does

• Restores the appliance's exterior appearance after dents, cracks, or corrosion.
• Provides structural support and mounting surface for the door, latch, and lower trim.
• Protects internal components from dust, debris, and accidental contact.
• Helps ensure proper door alignment and sealing when installed correctly.

• One outer front panel (quantity: 1)

• Disconnect power (and gas/water if applicable) before beginning any repair.
• Installation typically requires removing the door, trim, and/or control console to access mounting fasteners.
• Handle the panel carefully to avoid sharp edges and to prevent further cosmetic damage.
• Verify all mounting tabs and screws are secure and that the door aligns and closes properly after installation.