Chassis Or Cabinet

This oven floor deflector assembly restores proper airflow and heat protection in the lower oven cavity so food cooks evenly and internal components stay shielded from direct heat. It's a direct replacement for a damaged or warped deflector. What it does:

• Redirects and evens oven heat across the lower cavity to improve baking and roasting consistency.
• Shields internal insulation and components from hot bake/broil flames and debris.
• Replaces warped, dented, or missing deflector that can cause uneven cooking or rattling.
• Helps prevent direct flame contact with oven floor and lowers risk of food drippings burning on surfaces.

• One bottom oven and deflector assembly

• Disconnect power to the appliance and allow the oven to cool completely before starting.
• Basic hand tools are typically required; follow the appliance service manual for panel removal steps.
• Handle edges carefully—metal parts may be sharp.

Left hand side

Fix a compactor that won't start when the door closes. This actuator switch kit includes a redesigned, more durable switch. DIY install in 30-60 minutes.

Replaces the inner cavity bottom panel in your oven's bake compartment. Order if your original panel is warped, rusted, stained, or damaged from use.

Bottom burn box replaces the lower gas burner housing in compatible gas ovens, securing the burner assembly and helping direct heat for steady cooking while protecting internal oven components from flame and debris. What it does

• Houses and positions the lower burner assembly to ensure proper flame direction and ignition.
• Channels heat across the oven floor for more even cooking.
• Shields internal components from direct flame, food spills and debris.
• Common symptoms it can address: burner won't stay lit, irregular or uneven heating, visible corrosion or physical damage to the burner area.

• Always shut off gas supply and electrical power before inspecting or replacing gas-oven components.
• Inspect surrounding gaskets, mounting hardware and the burner assembly; replace any damaged parts.
• Follow OEM service instructions and safety guidelines specific to your oven model.

Cabinet base assembly for washers. Replaces cracked, rusted, or corroded base frames. Installs at bottom of washer cabinet to support unit weight.

This is the mounting base that supports and secures the bake element at the bottom of the oven cavity. It provides a stable platform for the heating element and helps direct heat properly during baking. Replace this part if it is cracked, warped, or corroded, which can cause the bake element to sit unevenly or make poor electrical contact.

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.