General Electric Gas Conv Kit Parts

This high-altitude conversion kit adjusts gas flow for ranges and ovens to improve burner and oven performance at higher elevations. It helps restore consistent flames and more even cooking where factory settings are optimized for sea level. What it does:

• Replaces or adds components needed to change the appliance to high-altitude gas settings
• Helps correct weak or irregular burner flames commonly seen at altitude
• Improves oven temperature stability and baking results when elevation affects performance
• Reduces the need for repeated manual adjustments to burner or oven controls

• Installation requires turning off the gas supply and following the appliance's service manual
• Follow OEM instructions exactly for orifice changes, regulator adjustments, or other modifications
• Verify seals and connections for gas leaks after installation using approved leak-detection methods
• Do not attempt conversion on electric-only appliances

This conversion kit assembly adapts your gas appliance for the correct fuel type specified for your model, restoring proper flame size and heating performance after a fuel change and supporting safe, efficient operation.

• Converts the appliance for the designated gas type per the manufacturer's instructions
• Calibrates burner output for proper flame characteristics and heat
• Helps address yellow flames, sooting, weak heating, or hard-to-adjust flames after a fuel change
• Supports reliable ignition and stable flames when the supply differs from the factory setup

• Turn off gas and electrical power and allow the appliance to cool before service
• Install each component in its specified location; do not mix sizes; retain removed parts for possible reconversion
• After installation, leak-check all connections and verify flame appearance/air adjustment; apply required conversion identification as instructed