Maytag Control Board

The washing machine intermittently would not agitate or spin. A reset of the timer dial fixed it. Then nothing fixed it. Originally thought it was the timer but father wanted to check out other possibilities. So he brought his meter over and went through all that he could, including checking power to the motor below. All was good electrical-wise. On the holiday, January 1, a rep. at AppliancePartsPros assured me that if a new timer did not fix the problem, I could return the item, even... Read more

Took out old timer, and upon inspection notice some electrical arcing( burned areas). I installed new timer and worked perfectly. Problem was that it would fill up with water, but after it was filled the timer kept going but washer was not agitating. Only thing that worked was delicates wash. Important Disconnect/ unplug power cord! 1. Remove knob, center cap pops off revealing a pin. Slide that off and the knob should come off. 2. Removing knob should reveal 2 socket screws remove... Read more

Replaced the defrost timer. It was not located where the parts explode suggested in the thermostat control box which is located in the upper right corner of the liner. It was in fact outside the freezer compartment on the back lower left support (when looking at the back of the freezer). It is secured with 2 sheet metal screws with a 1/4 hex head. The manual override dial is visible through a punched hole in that support. Just remove the 2 screws, disconnect the electrical connector. Then... Read more

• Freezer not defrosting

I had had the same problem 4 or 5 years ago and spent close to $200 to repair it. I did have the slip from that repair with part #'s so I went ahead and ordered a defrost timer and thermostat. You-tube had plenty of videos on replacing those parts and even before they arrived I was able to add a switch and bypass the broken thermostat and start a cycle manually with the timer. (which it seems was was still functional). Between that and cycling some ice packs up from the still working... Read more

Replaced ignitor. Watch the u-tube videos for removing and replacing the board and ignitor. Read more

Oven is a slide in. I pulled it out just a Few inches and removed 8 screws and Pulled the face down to expose the unit. The control unit had 4 screws and 4 Plugins. It only took me less than 10 Minutes to replace unit and slide back In place. Read more

Replaced with part No.AP4417276 electronic control board that we ordered from you and replaced it ourselves with your professional assistance. This has been an excellent experience with your company, and your return policy. Thank you . Read more

SIMPLY followed the U-2 video posted at Appliance Parts Pros. It was so easy and probably saved us a couple hundred dollars (in parts mark-up and labor) compared to hiring it out. It was a 10 minute job and it was done. Jeff PS. I ordered the part Sunday PM and received the part Tuesday morning...THANKS! Read more

I don’t think I needed the capacitor and relay, but while I was at it I figured I would. Originally we found we had an issue when water cane out of the ice maker. The freezer was hovering around freezing and the refrigerator was about 33 deg. I unplugged the refrigerator and it came back on and ran about a day. The next night, same thing. This time cycling power did not seem to help. Removing the rear cover where the control board was and moving it around allowed it to turn on next time I... Read more

Swamped out the control panel. Problem fixed. Read more

The basin would fill but would not agitate, there was no sound, no grinding noises, no sound of a motor running without agitation due to a broken belt. The basin full of water was able to drain if I advanced the timer to Spin. By playing around with the timer dial further, I could get every function of the washer to operate, at least partially. So, that said electrical problem to me. I assumed the trouble was either the safety switch at the back of the lid or the timer mechanism. Tested... Read more

• Freezer not defrosting

I took the bottom tray out of the freezer and found the coils iced up severely. I was reasonably sure the defrost timer was the problem and your tech said that was a good possibility. Ordered and replaced timer. (15 minutes) Problem fixed!!! Saved purchasing a new fridge at big bucks. We live over 40 miles from a service center so the cost of having a tech come out is astronomical. Thanks!!! Read more

Replaced new motherboard and face plate. Read more