Screws, Nuts, Washers

Bolt socket hardware for refrigerator assembly and structural support. Replace if cracked, stripped, or missing to secure components properly.

Hex nut secures internal components and fastens panels inside your refrigerator. Replace if stripped, corroded, or missing during appliance repair work.

Secure hex bolt for microwave assembly. Replaces lost, stripped, or damaged mounting bolts. Essential hardware for panel attachment and stability.

This screw fastener secures appliance panels and components to keep assemblies stable during normal use. A simple replacement for damaged or missing screws that restore proper fit and reduce rattling. What it does:

• Holds appliance panels, brackets, or trim in place to prevent movement
• Helps stop vibrations and rattling caused by loose hardware
• Replaces stripped or corroded screws that no longer tighten properly
• Restores a flush, secure fit where a matching screw is required

• One screw as shown

• Disconnect power and follow safety procedures before servicing the appliance
• Use the correct screwdriver or bit to avoid stripping the screw head
• Seat the screw straight and tighten until snug; do not overtighten to avoid damaging parts
• Keep removed hardware organized to ensure correct reassembly

Mounting screw secures panels, brackets, and components to the appliance frame. Replace if stripped, rusted, missing, or damaged during service.

Retaining clip secures panels and assemblies in dishwashers, dryers, and laundry centers. Replaces worn, broken, or missing clips to restore fit.

Plastic push-in rivet fastener secures trim and panels on electric ranges and ovens. Replace if broken, missing, or worn to prevent loose rattling parts.

Hex washer-head screw secures panels, brackets, and internal assemblies. Replace missing, stripped, or rusted fasteners to restore tight fit.

Replacement mounting screw for electric and gas ranges. Secures internal components and panels. Needed when original screws are stripped, missing, or lost.

Replacement mounting screw that secures the thermostat assembly to your range cabinet. Replace if stripped, missing, or damaged during repair work.

Secures the burner valve assembly to your gas range. Replace this mounting screw if worn, missing, or stripped to restore proper valve alignment and support.

Size: 8-32 x 5/8 inch.

A replacement silicon controlled rectifier (SCR) that restores proper high-current switching for heating or ignition circuits. Replacing a failed SCR helps stop intermittent heating, loss of element power, or erratic control behavior. What it does:

• Switches and regulates high-current power flow to heating, ignition or motor circuits when gated by the appliance control.
• Prevents or causes intermittent/no-heat conditions when failing or shorted.
• Stops erratic cycling or loss of controlled power to the affected circuit.
• Operates as a direct electrical replacement for the factory SCR specified by the appliance manufacturer.

• Disconnect power before servicing; this part is used in high-voltage sections.
• Match part number and orientation exactly; some installations require soldering or secure connector seating.
• Discharge capacitors and observe ESD precautions when handling electronic components.

Stainless steel hex washer head screw for securing appliance panels, brackets, and trim. Replace missing, stripped, or corroded fasteners during repair.