Trim

Replace your range's vent trim if the original is cracked, damaged, or missing. This cosmetic trim piece frames the ventilation opening for a finished look.

Replaces the front vent trim on your range. Restores airflow appearance and prevents debris from entering the vent area. Needed when cracked or missing.

Bottom cabinet trim assembly for ovens. Installs at the base of the cabinet to provide a finished appearance. Replace if cracked, broken, or missing.

Replace cracked or missing 27-inch stainless steel trim on your oven. Restores the finished edge and professional appearance of the appliance front.

Replace your 30-inch oven's front trim assembly when the original is dented, scratched, or chipped. Restores a clean, finished look to the appliance edge.

Trim assembly for ovens. Installs around the control panel or door edge to provide a finished appearance. Replace if cracked, bent, or missing.

Rear trim panel for cooktop. Replaces damaged, cracked, or missing trim along the back edge. Restores clean appearance and finished look.

This landing edge kit replaces the worn or damaged landing edge on compatible GE appliances to restore a secure, even door or panel fit and reduce drafts or rubbing. Designed as a direct-fit service part for affected models. What it does

• Replaces the landing edge strip that provides a finished, cushioned contact surface for a door or panel.
• Helps stop scraping, rattling, or uneven closing caused by a worn or torn landing edge.
• Restores the proper seal/contact area to reduce air leaks and improve door alignment.
• Keeps surrounding trim from wearing prematurely by providing a consistent contact surface.

• One landing edge kit (ZDP) as shown.

• Verify accessibility and remove power from the appliance before starting.
• Clean the mounting area and remove old adhesive or remnants to ensure good fit and adhesion.
• Use appropriate hand tools; avoid sharp tools that could damage adjacent trim or seal surfaces.
• Follow any model-specific instructions in the service manual for proper positioning and attachment.

Front trim panel for range griddle. Replaces cracked, chipped, or worn trim pieces. Installs along the front edge of the griddle for a finished look.

This left side trim piece replaces a damaged or missing side trim to restore the cabinet edge and finished appearance of the appliance. It helps maintain a flush fit and clean look along the refrigerator side. What it does:

• Covers and protects the exposed edge of the cabinet for a finished appearance
• Restores proper trim alignment to reduce gaps and rubbing against adjacent surfaces
• Replaces cracked, dented or missing trim that detracts from the appliance finish
• Helps maintain a uniform seal and appearance after service or collision repair

• Always unplug the appliance or turn off power before starting cosmetic or trim repairs
• Installation typically involves removing any adjacent molding or fasteners and snapping or fastening the trim into place; keep original fasteners if reusing
• Handle edges carefully to avoid cuts or damaging adjacent panels

This is the right-side front trim piece for the appliance door—a finished stainless steel replacement that restores the door's appearance and protects the door edge from damage. What it does:

• Covers and finishes the right front edge of the door for a factory look
• Protects the door edge from chips, nicks and everyday wear
• Replaces scratched, dented or bent trim that affects appearance
• Helps keep seals and adjacent trim aligned by restoring original fit

• One right-side front trim piece (stainless steel)

• Disconnect power to the appliance before starting any repair
• Remove the door or panels per OEM instructions to access trim fasteners
• Use non-marring tools and a soft cloth to avoid scratching finished surfaces
• Retain all screws and clips; reuse only the fasteners specified by the manufacturer