Washer Switch

Fix an oven that won't switch between bake and broil modes with this rotary selector switch. Controls oven functions and temperature selection reliably.

Fix a washer that won't advance through cycles or gets stuck mid-cycle with a new cycle switch. This repair typically takes 30-45 minutes.

Fix a washer that won't fill with water or overfills with this water level pressure switch. Controls proper fill levels during wash cycles.

Fix a washer that won't advance through cycles or stops mid-program. This cycle selector switch controls wash cycle progression and timing sequences.

Fix a washer that won't change water temperature or cycles incorrectly with this water temperature switch. Simple repair restores proper wash cycle control.

This cycle selector switch is the user control that selects and advances cooking/drying cycles, restoring reliable cycle selection and user control on compatible appliances. It provides a direct replacement for a worn or non-responsive selector. What it does:

• Rotates to select the appliance cycle and sends the chosen setting to the control system
• Restores proper cycle selection when the knob or control no longer changes settings
• Commonly used when cycles won't start, don't advance, or the control feels loose or intermittent
• Works as the mechanical/electrical interface between the user knob and the appliance control

• Disconnect power to the appliance before beginning any work
• Remove the control knob and panel trim to access the switch—keep track of screws and small parts
• Note or label wire locations before disconnecting; reconnect wires to the same terminals
• Test cycle selection and appliance operation after installation; if issues remain, check related controls and wiring

Fix a washer that won't fill properly or overfills with this water level pressure switch. Controls fill cycles based on load size. DIY repair.

Fix a washer that overfills, underfills, or won't fill at all with a new water level pressure switch. Controls fill cycles based on load size.

Fix a washer that won't fill properly or overfills with this water level pressure switch. Moderately easy repair—access control panel and twist off old switch.

If your washer won't start the correct cycle or the dial feels unresponsive, this cycle selector switch restores proper program selection and control.

Washer won't start or stops mid-cycle? A faulty door switch prevents operation when the lid isn't detected as closed. Common DIY fix in 30 minutes.

Fix washer overfilling and water spilling over the tub with this pressure switch. Simple 3-wire installation stops overflow issues. DIY-friendly repair.

Fix washer overfilling or not filling properly. This pressure switch senses water level and signals the control board. Straightforward DIY repair.