Admiral Parts

I replaced the washer plate and new screw/washer part. Easy fix and back up and running in ubder 10 minutes. Read more

• Element will not heat

Not really a repair, just needed to update some parts that were worn out. Drip pans were perfect and I am so glad to have found them on this location. Read more

I previously ordered the heating element, thermostat, and fuse. Also the rear drum rollers. However, after completing that repair I noticed that the terminal block and power cord had some damage from an apparent overheating while allowing the dryer to continue to run in order to dry the clothes. All is well now and the unit is working just fine. I appreciate the quick delivery of all 3 orders. Read more

• Shakes and moves

New leveler pads Read more

We found the right ice cub bin/pan, ordered it, and it arrived quickly. Fit perfectly, and it is now catching our ice. Read more

Replaced with new retainer clips and new capacitor to fix future problems Read more

Acualy sounded and looked major but with a littel help with you tube the job only took 30 minutes. 3 bolts for the water pump pulley broken pulley poped off new one klick into place simple belt install good to go. Parts saved me $40 and where here in only 2 days. I couldnt be happyer. Read more

Bought and installed new hinges. Repair took about an hour but I also cleaned all the glass inside and out on both oven doors. I had ordered extra screws as I read the old ones that hold the hinges were hard to get in as they were self taping but the screw labeled 5 next to the hinge were not the right ones. All old screws worked fine. You just need to put a little power to them to get them started. Easy repair. Read more

Ordered the gasket kit. The shipping time was quick. The installation was more difficult than anticipated. The inside of the door had to be removed there were about 30 hex head screws. the new gasket then had to be fitted to the interior of the door and then placed on the outer part of the door and the screws replaced. The screw replacement took longer than anticipated as there were eight corner screws that were very difficult to manage because of the inside design of the gasket. The screws all... Read more

The removal of the ice bin and auger motor was easy but removing the auger from the shaft was another story. The auger was frozen to the shaft even after it sat out overnight. I carefully applied heat with a propane torch, directly on joint of the auger and the tip of the shaft, followed by a few drops of cold water. Once the shaft and auger cooled the auger separated easily. Putting the components back together was simple taking about ten more minutes. Read more

Bought a new one that you had available. Best reliable source I have found to date. Read more

• Shakes and moves

Took off the old parts and replaced with the new parts Read more

I have a 25 year old Kenmore washer that works well and didn't want to get a new washer as they don't make them like they used to. Upon removing the top cap of the agitator and doing an inspection, the agitator dogs were completely broken into pieces. Due to age we decided to replace the lower and upper agitator along with the agitator auger dogs repair kit. All new parts and works fine. On inspection of old parts, we probably could have gotten away with just a $5 repair for the plastic... Read more

Bought replacement burner receptacles. Cut off the old ones, used wire nuts to connect replacements. Read more

Replaced the motor wax door lock switch and the door lock spin enable switch. Read more

I have a 25 year old Kenmore washer that works well and didn't want to get a new washer as they don't make them like they used to. Upon removing the top cap of the agitator and doing an inspection, the agitator dogs were completely broken into pieces. Due to age we decided to replace the lower and upper agitator along with the agitator auger dogs repair kit. All new parts and works fine. On inspection of old parts, we probably could have gotten away with just a $5 repair for the plastic... Read more