Need Help?
Call
Adhesive overlay that covers and labels the control board buttons on your range. Replace when faded, cracked, peeling, or damaged from heat exposure.
Purchased a new over control board and overlay. Installed in five minutes, and everything works great now. Shipping was super fast, and was here within two days. Read more
Adjustable hinge kit for refrigerator doors. Includes components to secure and adjust door hinges. Replace if worn, broken, or door won't seal properly.
Ordered the replacement parts and had them the next day! Very nice. Read more
Freezer door gasket seals the door to prevent warm air entry and cold air loss. Replace if torn, cracked, or not sealing properly. Confirm fit by model.
Gasket and liner arrived as planned. Clips were a day later. Used "hog ring" pliers to remove the clips, worked great. Pre-punched holes in the gasket did not match the original but the plastic liner did. Used an ice pick to punch the gasket and inserted the clips. This is a chest freezer, so install the hinge side first. Read more
Ice won't dispense but door opens? This dispenser auger motor powers the auger that pushes ice through the chute. DIY-friendly repair with video guide.
The tech was very helpful. We needed a new motor. Read more
The Control Board is an OEM part for Frigidaire ranges. This part manages and regulates the functions of the range, including the oven temperature, cooking modes, and timing, ensuring precise control and efficient operation.
Causes of a bad control board can include electrical surges, overheating, or component failures due to regular wear and tear.
Symptoms of a bad Control Board include:
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
I googled the error code and symptoms my oven was exhibiting to determine the solution and which parts to order. I needed a new control panel and chose also to replace the overlay that shows on the front of the stove. I could have reused the old one because I turned out to be able to remove it without damaging it. I just kept it in case I damage the new one in the future. The “fast” shipping (not overnight) option had the part delivered the next morning, which was a nice surprise. I felt... Read more
Freezer running too warm or freezing food? A faulty defrost thermostat disrupts temperature regulation. Moderate DIY repair restores proper cooling.
Checked compressor windings - ok. Start relay looked no rattle or burning. Start capacitor seamed ok but hard to check. No 120VC to start relay at any time. Ordered thermistor, and electronic control unit. Figuring it was a bad thermistor not telling the ECU it was warm and to turn on the compressor. Or the ECU was damaged and was not sending the 120v to the compressor. Changed the thermistor first (cheapest part and as Appliance parts pros has a return policy I wanted to start there). ... Read more
Secures the ignitor assembly to your gas cooktop burner base. Replace if screw head is stripped, threads damaged, or screw is missing after disassembly.
It took a little longer then I was hoping but wasn’t terrible. If the burner is very old at all make sure to get the new screws. Both of mine snapped when trying to remove them. The new one works great. Read more
Compressor clicks but won't start? Replace the start relay when your freezer stops cooling or the compressor shuts off after a few seconds. Quick fix.
First I have an LG French Door with a bottom freezer. It quit cooling. I went on line and watched some very informative You Tube videos. I trouble shot according to these videos. In these videos it shows that if there is a click coming off the compressor it has too meanings, the compressor is froze or the start relay is bad. I ohmed the compressor and had no open wires in the compressor. I then shook the relay and it was making noise. The videos stated that is there is a noise in the relay... Read more
The Range Cap is an OEM part for Frigidaire ranges. It seals the upper combustion chamber to contain heat from the oven burners. A tight-fitting cap is critical for efficient, safe oven performance. This cap measures 3 inches in diameter.
Causes of a bad cap can include cracks, warping, or collapsed seals from prolonged exposure to high oven temperatures. Accidental damage during past maintenance is also possible.
Symptoms of a bad cap include:
This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.
Ordered replacement parts Read more
Oven not reaching set temperature or shutting off mid-cycle? This temperature sensor monitors cavity temp and signals the control board. 15-min fix.
Online chat here said that the oven sensor should be replaced. I got the feeling that was a bit off, so I went with my gut and ordered the thermostat as well. Replaced the sensor and that didn't fix it. Replaced the thermostat and it worked like a charm! Disappointed that they were overconfident in their answer and it would have taken me more days to fix - but, the products came in quickly (basically, next day) and were correct. Online video for my particular oven was incorrect - but it's... Read more
The Moisture Sensor is an OEM part for Frigidaire dryers. This essential component detects the moisture level in the dryer drum during a drying cycle. It plays a crucial role in determining the optimal drying time, preventing over-drying or under-drying of clothes.
A faulty moisture sensor can be caused by various factors. Over time, the sensor may become coated with lint or residue, affecting its accuracy. Additionally, electrical malfunctions or physical damage can lead to sensor failure.
Symptoms of a bad moisture sensor may include:
Simple unscrewed the set screw, removed the broken sensor-moisture part, attached the leads, and reattached the part to the back of the dryer. Took about 4 minutes. Read more
Washer won't fill with water or only fills with hot? The water inlet valve controls water flow into the tub. DIY repair takes about 30 minutes.
This is my third repair of this type. The first was a stand-alone washer and was very easy, because there was a plate on which the inlet valve assembly was mounted, and it was easily removed. This repair was on a Frigidaire stacked washer/dryer (laundry center). Stacked washer/dryers are typically purchased to save space and are often tucked into a closet. Be sure you can pull it out to access both front and rear. Remove drain hose from drain, detach water hoses, electricity and dryer vent... Read more
Replaces broken or worn lower door closer cam on side-by-side refrigerators. Essential for smooth door operation and secure closing. Order today.
I called Appliance Parts Pro told them what I needed it and the model of the refrigerator. They told me exactly what I needed and also made suggestions to make sure I had enough parts to accomplish the task. Read more
Washer won't spin or shows communication error? The motor control board controls spin speed and motor functions. DIY repair in 30 minutes with video guide.
This was the motor control board (also called the speed control board, motor control unit, or MCU in various places across the web). The repair was straightforward, except for two complications. First the old part was difficult to access in this model washer (Frigidaire Gallery Series front load washer). Instead of being easy to reach on the left side where there was space, it was sort of behind the actual motor on the right side of the housing. I spent some time trying to figure out... Read more
Drip tray installs below the water and ice dispenser to catch spills and drips. Replace if cracked, broken, or tabs are damaged causing it to fall out.
So I ordered the face plate and other parts that went with it and fixed it myself. The repair man wanted around $600 to do it. I believe kt cost around $160 to fix it myself. Read more
Fix a washer that won't fill, overfills, or shows E35 error code with this water level pressure switch. Moderate DIY repair takes about 1-2 hours.
Water valve not closing all the way. Water keep entering washer even with power cord unplugged. Parts I ordered fit perfect. Ordered on Thursday night , parts there Saturday. Great service and shipping. Thank Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.