Hose Or Tube

Model# MAV7257AWW Maytag Atlantis Washing Machine. Repairs were fairly easy along with the videos appliancepartspros offers on their website. Parts also came with instructions on how to install. Other videos were available on You Tube. The only part difficult to install was Thrust bearing kit - make sure when installing to pull down on shaft so washer and e-clip will fit. Another note, you can get a pulley for your replacement motor pulley on eBay and Maytag.com. Just pay close attention to... Read more

Installed a new hose and coupler and now it works perfect again. Had to take the top off of the dishwasher, which was just a few screws and take the old hose out, install the new one and within an hour, my dishwasher was running again. This company shipped my parts in "lightning speed" and I am very satisfied. Read more

Simply open the top of the washer by inserting a putty knife (watch YouTube ) and then the front panel by removing two bottom philips head screws on the front. The whole front panel comes right off. Using pliers the spring clams holding each hose, they come off and each hose is replaced. The drain one was only leaking but since it has open I changed both and even the drive belt. Whole job less than 1 hour. BTW parts arrived next day! Read more

Perfect fit. Thanks! Read more

Ordered parts, watched videos and had it like new in five minutes! Read more

Opened the back of machine and saw that a mouse had eaten holes in all but one of the rubber hoses. Took the top off the machine for better access. Appliance Parts Pros were the only company I could find that had all the pieces I needed in stock. Quick and easy to order online and fast shipping. Replaced the damaged hoses. Everything fits great and was easy to install. Definitely a diy project. I have even booked marked Appliance Parts Pros. Thank you Appliance parts Pros. Read more

Our dishes were getting mostly clean but we started finding really fine food particles inside cups/bowls (especially our tall travel mugs). Very long story short, the rubber flapper valve in the adapter assembly had warped and was no longer closing, so dirty water was remaining in the tub during the rinse cycle. I may just buy an extra since it will probably fail again in a few years and I'll need to replace it again. Read more

Our washing machine door boot seal was getting moldy and causing odor problems. Cleaning tablets and bleach weren't helping so it was time to be replaced. While I had the top and front off I changed all the hoses that could be collecting soap scum and mold, all other wetted parts were removed and washed. The video on the door boot seal, and inlet valve assembly were extremely helpful in understanding how these parts are removed and reassembled. Although the door boot seal is the most visible... Read more

Replaced Read more

Replace the entire assembly, manifold, spray arm with seal and water probe. Took 5 minutes. Problem solved! Read more

Read directions on how to change the power cord and watched video on your site on how to change the drain hose. Everything went perfectly. Read more

• Leaking