Hose Or Tube

This is a drain hose extension designed for dual evaporator refrigerators. It connects to the existing defrost drain system to route condensate water to the drain pan. Replace this part if you notice water pooling inside the refrigerator, leaking onto the floor, or ice buildup in the freezer compartment due to a clogged or damaged drain line.

Routes wastewater from your dishwasher to the sink drain or disposal. Replace if your existing hose is cracked, leaking, kinked, or too short for installation.

Size: 8 foot long. This external washer drain hose is needed when there is more distance between the washer and the drain. Note: comes with 1.5" diameter clamp but hose is 1.25" in diameter; therefore you may need to order the 1.25" diameter clamp separately: WP356138

This inlet hose carries supply water into the washer during the fill cycle. Replacing a worn or leaking hose restores proper water flow and helps prevent leaks and fill errors that can leave clothes unwashed or floors wet.

• Channels incoming water from the inlet valve into the washer
• Maintains a sealed connection to prevent drips and leaks
• Replaces hoses that are cracked, swollen, kinked, or clogged with mineral deposits
• Common symptoms: water leaking during fill, reduced water flow or fill error codes, visible cracks/splits

• Disconnect power and turn off both water supply valves before servicing
• Keep towels or a container handy; residual water may spill when removing hoses
• Note hose routing; fully seat ends and secure with existing or new clamps as required
• Restore water and power, then run a quick fill to check all connections for leaks

This is the chute component that directs water from the fill tube into the ice maker mold inside the freezer compartment. It ensures water flows accurately into the ice tray without spilling into the surrounding freezer area. Replace this part if water is leaking around the ice maker, ice forms outside the mold, or the chute is cracked or blocked with ice buildup.

Hose washer and plastic insert for inlet hose. To order separately: for washer use WPY013783, for strainer use WP22002960.

This is a flexible hose that connects the detergent or fabric softener dispenser to the wash tub, allowing dispensed products to flow into the drum during the wash cycle. If you notice detergent not dispensing properly, leaking near the dispenser area, or water pooling under the washer during the fill cycle, this hose may be cracked, clogged, or disconnected and needs replacement.

Replacement fill tube that directs water from the inlet valve into your refrigerator's icemaker mold. Replace if cracked, damaged, or causing leaks.

21-inch drain hose extension for washers. Extends existing drain hose when original is too short to reach standpipe. Includes clamp for secure fit.

Routes wastewater from your dishwasher pump to the home drain. Replace if cracked, kinked, punctured, or worn to restore proper drainage and prevent leaks.

This replacement tubing routes water to the refrigerator's ice maker. The 8-foot length is ideal for replacing aged, brittle, or leaking line to help maintain reliable ice fill and reduce the risk of leaks.

• Carries water from the inlet valve to the ice maker
• Replaces cracked, kinked, or leaking tubing
• Can help address symptoms like water under/behind the fridge, restricted flow, or little/no ice production

• Unplug the refrigerator and shut off the water supply before servicing
• Route along the original path; avoid sharp bends and cut ends square if trimming to length
• Ensure fittings are fully seated and tightened per your model's requirements
• Restore water, check all connections for leaks, and run a test cycle

This is a flexible drain hose that connects the washing machine's pump to the household drain standpipe or laundry tub. It channels used wash and rinse water out of the machine during the drain and spin cycles. Replace this hose if you notice leaks at the connections, cracks or splits in the hose material, or if the washer is not draining properly due to a restricted or damaged hose.

Channels wash water through your dishwasher's spray system. Replace if cracked, leaking, or clogged to restore proper water distribution and flow.

Drain line assembly routes defrost water from the evaporator to the drain pan. Replace if cracked, clogged, or leaking to restore proper drainage.

Replacement drain hose for washers. Routes wastewater from the drain pump to your household drain. Replace if cracked, leaking, clogged, or worn.

Replace your refrigerator's water inlet tube when cracked, split, or leaking. Connects water inlet valve to internal filter or dispenser system.