Maytag Valve

• No hot or cold water
• Will not fill with water
• Will not stop filling with water

Replaced the water valve. Easy repair. The repair video was spot-on. Tools needed: Slip joint pliers for removing and attaching the hoses and moving the hose clip. 5/16 nut driver. Phone to take a picture so I could get the wires put back right. Shut off the water and unplug from power. Remove the hoses. Using a 5/16 nut driver remove the single screw that holds the bracket, lift bracket slightly and pull from the washer. There is a little slack in wires and fill hose to work with. Take a... Read more

Removed valve and replaced with new one. Read more

• Not dispensing water
• Leaking

Being an ex maintainence. person, I went down and turned off the water supply. Then I started to try to find the leak by removing the rear covers for the compressor and valves. Once removing a couple of covers where the dual valve was, I spotted where the water was coming from.I then pulled the electrical plug from the wall. Between the solenoid and valve. I removed the screws that held the valve in place. Then disconnected the three hoses going into valve and removed the two electrical... Read more

• Will not fill with water

Ordered new inlet water valve and float switch kit. After repairs it now works fine. However the water inlet valve outlet end for fill hose (not water source) and wire connections (supposedly for this unit) were oriented 180 degrees opposite. I had to gently remove the blue plastic valve off the metal support bracket and turn it around and press back in place. Fortunately it appears it was designed for either orientation. Also the solenoid had to be unclipped and also rotated. Again it was... Read more

Remove the top panel by removing 3 hex nuts on the back of the washer. Inlet valve was located right underneath the panel towards the back. Remove one screw using a t20 bit and unplug the 2 plugs located on the valve. With a pair of pliers removed a tension clamp and the valve comes right off. Read more

Ordered 6 parts from you thanks to your fantastic web schematic parts diagram received parts very fast changed parts easily and that leak stopped. Your company is a 5* operation hands down. Read more

Saw the drip, ordered the part. Unplugged machine from wall. Torx bit on my DeWalt cordless drill to remove the screws securing the lid to the machine, lifted off top cover. Turned off water supply and removed the water supply hoses from back of the machine, used needle-nosed pliers to remove spring clamps from the defective part, removed mounting screw for defective part at rear of machine. Worked the defective part out of mounting, unplugged the three electrical connectors. Then, plugged in... Read more

The dual inlet valve was the problem. The hardest part of the repair was moving the refrigerator so we could unplug it. The whole job took about 25 minutes and that includes the time we spent emptying and reorganizing the shelves. I love AppliancePartsPros.com. We have used this website to fix our oven, washer, dryer and now the ice maker. Thank you AppliancePartsPros! We only used one screwdriver and that was only used to open the back panel of the refrigerator. Read more

The odor in the dishwasher was due to scum buildup in the walls, the racks, and in the lower part of the drain below the lower rotating arm. One of the valves in the vertical tube was stuck in the open position; since the valves cannot be replaced, the entire tube needed replacement. The check valve probably needed no replacement, but once I opened the bottom part, I decided to replace it anyway. I used this Youtube video to replace the tube, open and clean the drainage part of the washer: ... Read more

Replaced water inlet unit. Read more

• Will not fill with water

I ordered this new valve, and voila!!! No more using up all the hot water to wash everything. Now I can do all of my laundry with cold water, like I prefer to. Read more

• No hot or cold water
• Will not fill with water
• Will not stop filling with water

Ordered a new inlet water valve . Super fast delivery ordered on a Wednesday afternoon was here Thursday morning , standard shipping , I was impressed !! Removed the old valve , installed the new , checked for leaks no issues , washer is back on line and my Honey is very happy with me . Read more

My 15 year old whirlpool washer top was rotting away and my wife was about to buy a new one. a 1 min search on google brought me to this site and within 5 mins found all the parts I needed, Received my order in 3 days and now we're back in business for a total cost of $159 instead of $500 to $600. Will use this site again and have told a few people already. Thanks Rob Read more

• Will not fill with water

I figured the valve that allowed water into the dishwasher was bad, or some controlling function of this process. I went online, typed in model number and had a full exploded view of the parts in my dishwasher. I ordered the inlet solenoid valve as the first step to what may be wrong. Turns out this part was the problem. With the online video it made replacement a breeze. Thank you APP for the RIGHT part AND instructions. Online purchasing and delivery are easy and timely. Read more

Purchased Appliance Parts Pros replacement ice maker, removed the defective unit, matched the proper wiring harness using the wiring color codes at the P and J side connectors. Approximately 1 hour following the installation, I delightfully heard the first set of cubes ! Read more

I had verified that the water supply was healthy, so it was either the icemaker unit or the water valve. I replaced the icemake first, based on a the pareto showing it was the culprit for most other people, but it didn't help. That replacement was straightforward; the hardest part was reaching all the way back to unclip the wiring harness since I am too lazy to totally empty the bottom freezer and remove the door. So the next step was the water valve. The hardest part of this was pulling the... Read more