Shaft Or Pin

Control shaft for gas range knobs and controls. Replaces worn, broken, or missing shafts that prevent proper knob attachment or smooth operation.

Refrigerator roll pin secures moving parts and mechanical assemblies. Replace if pin is missing, damaged, or causing loose components in your unit.

Replacement washer shaft. Installs in various washer components including controls and drive assemblies. Order when shaft is broken, bent, or stripped.

Couples the motor to the turntable mechanism in your microwave. Replace if the original coupler is cracked, broken, worn down, or missing from use.

Replace the implement holder rod in your range hood. This mounting pin secures accessories and attachments. Order a new rod if yours is broken or missing.

Replaces the stud spring on refrigerator and freezer doors. Needed when the original spring is broken, worn, or missing, affecting door alignment.

Cross bar pinion gear for refrigerator ice maker or dispenser mechanisms. Replace if gear teeth are stripped, worn, or broken causing mechanical failure.

A small metal pin used to secure components in place so they stay aligned and operate smoothly. Replaces a worn or missing retainer pin to restore proper fit and reduce rattling or movement. What it does:

• Secures moving or removable parts by fitting into a mating hole or bracket
• Prevents components from sliding out of alignment during use
• Commonly used where a simple, durable fastener is required
• Symptoms of a bad pin include loose parts, unwanted movement, rattling, or components that detach

• Disconnect power (or unplug appliance) before starting any repair
• Remove adjacent panels or components as needed to access the pin
• Use pliers or a punch to remove the old pin and press the new pin into place; avoid excessive force that could damage surrounding parts
• If the pin secures glass or sharp components, handle carefully and wear gloves and eye protection

This pin locator secures a hinge or shaft pin in place to keep linked appliance components aligned and operating smoothly. It's a small replacement part that restores proper positioning where a locating clip or retainer is used. What it does

• Holds a hinge, shaft, or pivot pin in place to prevent lateral movement
• Restores proper alignment of doors, panels, or linked components
• Helps stop rattling, misalignment, or binding caused by a worn or missing locator
• Works as a direct replacement for the same OEM-labeled locating clip/retainer

• One pin locator

• High-level replacement; basic hand tools usually required
• Disconnect power (and water, if applicable) before servicing appliances with electrical components
• Keep track of small parts and orientation for correct reassembly

Threaded mounting stud secures your cooktop to the countertop or cabinet. Replace if stripped, broken, or missing to properly anchor the unit.

Secures ice crusher components in place. Replace if pin is worn, missing, or broken to restore proper alignment and operation of crusher assembly.