Touch Pad

Replaces the front touch pad control panel on your microwave. Needed when buttons are unresponsive, cracked, or worn. Restores keypad functionality.

User-facing button assembly for the dishwasher control panel. Replace when buttons are unresponsive, cracked, worn, or indicators are dim or missing.

Replacement dishwasher touch pad that installs on the control panel. Needed when the existing touch pad is cracked, peeling, unresponsive, or worn out.

Front user interface panel with touch controls and display for your range. Replaces a cracked, dented, damaged, or worn control surface panel.

This is the main electronic control board that manages all functions of the air conditioner, including compressor operation, fan speed, and temperature regulation. It receives input from the user controls and sensors to maintain the desired settings. Replace this board if the unit fails to turn on, does not respond to controls, displays error codes, or behaves erratically.

This electronic control board (main PCB) replaces the oven/refrigerator console's primary circuit board to restore control and user-interface functions. It provides the appliance's logic and power management so controls respond correctly. What it does:

• Serves as the appliance's primary logic/control circuit, managing buttons, displays, and timed cycles
• Can resolve symptoms such as unresponsive controls, blank or erratic display, or failure to start cycles
• Replaces a damaged or shorted PCB that may cause intermittent operation or consistent error indications
• Works with existing harnesses and mounts to re-establish electronic control signaling

• Disconnect all power (unplug or shut off breaker) before replacing the board to avoid shock or damage
• Handle the board by its edges and avoid static discharge; use an anti-static wrist strap if available
• Verify connectors align and seat fully; do not force plugs—match keyed harnesses

Fix a cracked or missing dispenser trim that leaves gaps around your water/ice dispenser. This bezel restores a finished look in about 15 minutes.

Replaces a cracked, unresponsive, or worn electronic control panel assembly. Installs on the front console to restore touchpad and display housing.

This main control PWB is the appliance's primary electronic control board that manages user inputs and cycle functions, restoring normal control when a faulty board causes operational issues. What it does:

• Receives user commands and runs appliance control algorithms
• Powers and updates the touchpad/display and indicator lights
• Manages timing, relay switching, and communication with sensors
• Common symptom: appliance won't start, has a blank or erratic display, or shows control-related error codes
• Helps correct unresponsive buttons, intermittent operation, or unexpected cycle behavior when board failure is confirmed

• Disconnect power (unplug or shut off breaker) before accessing the control board
• Handle the PWB by its edges and avoid static discharge; use ESD protection if available
• Refer to the appliance wiring diagram and service manual for proper connector placement and safety procedures

Replaces damaged, cracked, or unresponsive dishwasher control panel. Houses display and touch buttons for cycle selection and settings control.

Fix a bowed or damaged dispenser trim that leaves gaps around your refrigerator's recessed handle. This trim restores a clean, sealed finish. Easy install.

Replacement touch control glass panel for wall ovens. Installs over the control board interface. Order when original glass is cracked, scratched, or broken.

Replacement glass panel for the range control area. Restores finished appearance over the touch/display surface. Needed when original is cracked or scratched.

White control panel touch pad for washer dryer combos. Replaces cracked, broken, or worn touch pads with faded buttons or damaged surfaces.

Control panel touch pad for washers. Mounts on the console to house controls and display. Replace if cracked, damaged, or buttons no longer respond properly.

Replaces the exterior control panel face on your dryer. Restores faded, worn, or damaged button markings and labels for a clean, readable appearance.