Trim

Front frame lower trim for ovens and ranges. Covers the lower edge of the control panel area. Replace if cracked, chipped, discolored, or missing.

This filler panel assembly fills the gap between the dishwasher and adjacent cabinetry for a clean, finished look. Designed to match stainless or white finishes, it restores proper coverage and improves appliance appearance. What it does:

• Covers the gap between the dishwasher and cabinets to prevent debris and improve the look of the installation
• Restores the factory trim/edge where a damaged or missing panel exposes the dishwasher side
• Helps maintain a consistent finish between the appliance and surrounding cabinetry
• Compatible with factory mounting locations and trims when used as a direct-replacement part

• Designed for direct replacement using existing mounting points; keep original fasteners unless damaged
• Turn off power to the appliance before beginning work and follow all safety instructions in your appliance manual
• Use proper tools and a helper if needed; panels can be awkward to hold during alignment

This bottom trim assembly replaces the lower front trim on compatible 30" ranges and wall ovens, restoring a clean finished look and helping direct airflow. It's a direct-fit exterior replacement that refreshes damaged or discolored trim. What it does:

• Replaces the lower front/bottom trim piece to restore appearance and proper panel alignment
• Helps close the gap between the oven/range cabinet and the floor for a finished look
• Addresses symptoms like cracked, dented, warped, or yellowed lower trim
• Maintains proper airflow profile at the appliance base (cosmetic/exterior component)

• One bottom trim assembly (30" white) as pictured

• High-level swap: remove kick plate/old trim and fasten replacement with existing screws/clips
• Use basic hand tools; avoid force that could strip screws or damage adjacent panels
• Disconnect power at the breaker if service requires moving or tilting the appliance
• If mounting hardware is missing or damaged, verify exact fastener type before installation

This white middle trim assembly replaces damaged or worn center trim on compatible GE refrigerators, restoring a clean finished look and helping maintain proper door alignment and a consistent fit between doors. What it does:

• Replaces cracked, broken or missing center trim for a neater exterior appearance
• Helps maintain proper spacing and alignment between doors or panels
• Keeps dirt and debris out of the trim channel for smoother door operation
• Restores the intended fit where trim has become loose or warped

• Disconnect power to the appliance before starting any repair.
• Remove surrounding trim or screws as required; trim typically snaps or screws into place.
• Handle gently to avoid damaging adjacent panels or clips; replace any broken clips or fasteners.
• After installation, verify doors align and seal properly; make adjustments if needed.