Axle, Roller, Pulley Parts

Fix detergent door that won't open or latch properly. This dispenser plunger actuator restores mechanical engagement between the lid and release mechanism.

Replacement door hinge roller for ovens and ranges. Installs on the door hinge mechanism to allow smooth opening and closing. Order when worn or broken.

This genuine OEM replacement part is a pulley assembly for dryers. Sometimes called an idler arm, the pulley assembly keeps the dryer drive belt under tension as the belt wraps around the dryer drum. If the dryer is no longer spinning properly and is making a lot of noise, the pulley assembly may need to be replaced. Luckily this repair is a relatively simple process.To remove the old dryer pulley assembly, start by making sure the dryer is unplugged. Remove the lint screen from the top of the dryer. Remove the two Phillips screws by the lint screen opening. Depress the clips that hold the top cover down. Lift the top cover and keep it in an upright position. Disconnect the wire harness to the switch that separates the connector. Remove the screws on the front panel. Lift the panel forward and set it to the side. Next, lift the drum and locate the pulley assembly under the drum. Lift the belt off the motor pulley to remove the assembly. Set the new pulley assembly in the same position as the old one and make sure everything is aligned. Rotate the drum to make sure it rotates smoothly. reinstall the panels.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador dryers.

Spiral pin secures the roller axle in your dishwasher's lower rack assembly. Replace if the pin is missing, bent, or dislodged to restore stability.

Replace the lower dish rack roller assembly in your dishwasher. Needed when the rack roller is cracked, broken, or no longer rolls smoothly along the rails.

Replace worn, cracked, or missing range wheel and bracket assembly. Installs on the bottom of your range for smooth rolling and stability. Ideal fix for flat spots or broken wheels from frequent moving.

Replace worn or broken dishwasher lower rack wheels that cause difficult rolling or uneven gliding. Includes wheels and axles for smooth rack operation.

Replacement caster wheel for portable air conditioners. Installs on the base to allow smooth rolling movement. Order when wheel is cracked or broken.

Lower rack roller assembly for dishwashers. Mounts to the bottom rack to help it glide smoothly. Replace if cracked, broken, or wheels no longer roll.

This is a drum roller assembly that supports the dryer drum as it rotates during a cycle. The rollers allow the drum to spin smoothly and quietly on its support shaft. Replace this part if your dryer is making thumping, squealing, or rumbling noises during operation, or if the drum is not turning freely.

This is a small encoder wheel that attaches to the control knob shaft on the dryer. It works with the electronic control board to register the rotation of the selector knob, allowing you to choose cycle settings and options. Replace this wheel if the control knob spins freely without changing settings, clicks inconsistently, or if the dryer no longer responds to knob adjustments.

Replacement pulley for microwave turntable motor assembly. Installs on the motor shaft to drive the turntable rotation. Order if worn, cracked, or missing.

Plastic roller for downdraft range hood vents. Enables smooth up and down movement of the ventilation unit. Replace if cracked, worn, or binding.

Upper basket wheel and axle assembly for your dishwasher. Replaces worn, broken, or missing rack rollers that cause difficulty sliding the upper rack.