Cable Or Retainer

Cable retainer link for ranges. Secures and holds cables in place within your range assembly. Replace if broken, cracked, or missing to restore proper fit.

This retainer lever secures and positions a moving component inside the appliance so doors, trays, or assemblies operate correctly. Replacing a worn or broken lever restores proper engagement and prevents loose or misaligned parts. What it does:

• Holds and guides a mating part or linkage in place to ensure consistent engagement
• Prevents assemblies from slipping or coming out of position during use
• Helps restore normal opening/closing or indexing behavior when the original lever is cracked or broken
• Works as a direct-fit replacement where the factory lever has failed

• One retainer lever

• Install with power disconnected and any moving assemblies supported or restrained
• Inspect adjacent clips, pins, or fasteners and replace if damaged—only the listed lever ships
• Use basic hand tools; avoid forcing components—ensure correct alignment before fastening

Power cord retainer secures the electrical cord to your refrigerator's back panel. Replace if the original clip is cracked, broken, or missing.

This plastic filter holder retainer secures the refrigerator water/air filter assembly in place so the filter stays seated and sealed for reliable operation. Durable molded plastic matches OEM fit and mounting points. What it does

• Holds the filter assembly firmly in the housing to prevent loosening or misalignment
• Helps maintain a proper seal so water and air flow through the filter as intended
• Commonly replaced when the retainer is cracked, broken, or fails to latch
• Fits the original filter housing mounting points for correct engagement

• One plastic filter holder retainer

• Basic hand tools may be required; access the filter housing per your model's service instructions
• Inspect the filter and housing for damage before installing the retainer
• Replace only with the matching part number to ensure proper fit and secure latch
• Disconnect power/water supply if required by your model before servicing

This is a retaining ring used to secure components like shafts, bearings or seals in place to prevent axial movement. It provides a simple, durable hold so parts stay aligned and operate reliably. What it does:

• Secures shafts, bearings, seals or similar components to prevent shifting or axial play
• Keeps assemblies aligned to reduce noise, vibration and premature wear
• Restores proper part engagement after a worn or broken retainer causes looseness
• Helps maintain safe operation by preventing components from sliding out of position

• One ring retainer

• Disconnect power and unplug the appliance before any repair
• Use the correct retaining-ring pliers or tools to remove/install to avoid damage
• Verify orientation and seat the ring fully into its groove; a partially seated ring can fail
• Replace if bent, cracked or worn; do not file or reshape a damaged ring