Cable Or Retainer

This oven door insulation retainer secures the insulation inside the oven door, helping maintain proper heat containment and preventing insulation from shifting. It's a small but important clip that keeps the door's inner components stable. What it does:

• Holds inner door insulation in place so insulation stays positioned during use
• Helps maintain consistent heat distribution by preventing insulation gaps
• Reduces rattling or movement of the door interior when opening or closing
• Commonly replaced when insulation is loose, visible, or shifting inside the door

• One oven door insulation retainer

• Disconnect power to the appliance before beginning any repair to avoid shock or injury
• Access typically requires removing the oven door or inner door panel — follow your model's service instructions
• Handle door panels and insulation carefully to avoid damage; keep fasteners organized for reassembly

This small replacement linkage secures and positions the pan-chill assembly in compatible refrigerators, helping keep the drain/collector aligned and reducing movement or vibration. Replace a broken link to restore stable pan alignment. What it does:

• Connects and secures the pan-chill (drain/collector) assembly to the fridge framework
• Keeps the pan aligned for proper drainage and to prevent water pooling
• Reduces rattling or movement caused by a cracked or worn linkage
• Helps maintain correct spacing so adjacent components fit and operate without interference

• One linkage pan-chill mounting link

• Disconnect power to the appliance before starting work
• Access may require removing interior panels or shelving—keep fasteners organized
• Install by aligning the linkage with mating tabs and snapping or fastening into place; do not force broken plastic

This left-hand link actuator moves a device linkage to restore proper mechanical motion in the appliance. Replacing a worn or broken actuator helps stop erratic movement and restores reliable operation at the affected linkage. What it does:

• Converts motor or lever movement into motion at the left-hand linkage
• Replaces a cracked, stuck or broken actuator that prevents proper linkage movement
• Can stop clicking, grinding or failed movement caused by a damaged link actuator
• Works where a left-side linkage needs an exact-fit actuator to restore function

• Disconnect power to the appliance before starting work
• Remove only the panels and fasteners necessary to access the actuator; label connectors if needed
• Handle plastic tabs and mounting points carefully to avoid breakage during removal and installation
• Reconnect wiring and test the mechanism through a full cycle before reassembling all panels

A simple replacement mounting strap used to secure internal components and prevent movement or vibration. Replaces a worn or broken strap to restore proper support and reduce rattling or sagging inside the appliance. What it does:

• Secures panels, assemblies or harnesses to keep parts in place during operation
• Reduces vibration and rattling caused by loose or damaged straps
• Prevents chafing or movement that can lead to wiring or component wear
• Helps maintain correct alignment of the secured component for reliable performance

• Disconnect power to the appliance before beginning any repair
• Use appropriate hand tools; avoid over-tightening fasteners which may damage the strap or mounting points

This retainer is a small mounting clip that secures interior components so they stay in place and operate quietly. Replacing a worn or broken retainer restores proper fit and prevents parts from shifting or rattling. What it does:

• Secures shelves, panels or trim to the appliance cabinet to maintain correct alignment
• Prevents interior parts from shifting, rubbing or producing vibration noise
• Helps keep seals and trim seated properly to maintain a tight fit
• Commonly replaced when clips are cracked, missing or fail to hold components

• One retainer clip as pictured

• Disconnect power before servicing to avoid shock or injury
• Remove only the panels or shelves necessary to access the damaged retainer
• Install clip in the original orientation; retained component sits flush and is secure
• Use basic hand tools as needed