Dispenser Parts

This bleach dispenser box is the plastic reservoir that holds and directs liquid bleach into the washer during the wash cycle, helping the machine deliver bleach safely and evenly. Fits select GE top-load washers. What it does:

• Holds liquid bleach until the washer adds it at the correct time
• Directs bleach into the wash tub to prevent concentrated bleach contact with clothes
• Helps prevent leaks from the dispenser area when functioning properly
• Common symptom: cracked or warped box causing leaks or bleach not dispensing

• 1 bleach dispenser box

• Turn off power and shut off water supply before starting work
• Replace only with the exact part to ensure proper fit and sealing
• Inspect surrounding gaskets and hoses; replace if damaged to avoid leaks

Fix detergent leaking before wash starts or not dispensing properly. This washer dispenser cup holds liquid or powder detergent until the correct cycle phase.

This dispenser drawer handle trim assembly replaces the trim and handle piece on the refrigerator dispenser drawer for a clean, finished look and reliable grip. It restores proper drawer operation and user access to the dispenser area. What it does:

• Replaces damaged, cracked, or worn dispenser drawer trim and handle for improved appearance
• Provides a secure grip to open and close the dispenser drawer smoothly
• Helps keep the dispenser opening sealed and aligned for normal drawer function
• Addresses visible cosmetic damage and loose or broken handle symptoms

• High-level replacement; typically requires removing the drawer or access panel—refer to your model's service diagram
• Disconnect power to the appliance before starting work to avoid injury
• Handle parts may snap or screw into place; save any retaining clips or screws from the old part for reuse

Replace a broken or cracked washer dispenser drawer that won't close properly or is leaking detergent. Includes drawer, handle, and trim components.

Fix your washer dispenser drawer issues with this frame component. Supports drawer assembly operation and magnet placement. Direct-fit part for repair.

This detergent dispenser box is the molded housing that holds and guides liquid or powder detergent inside the washer dispenser assembly, helping deliver detergent into the wash at the proper time. What it does

• Houses detergent and channels it to the washer's wash tub during the cycle
• Prevents detergent from spilling or pooling in the dispenser area
• Helps ensure measured detergent flows into the machine when the cycle starts
• Common symptom: detergent stays in the drawer or does not fully dispense

• Disconnect power (and water if applicable) before service
• Handle the housing carefully to avoid cracking plastic tabs or seals
• Inspect adjoining seals, slides, and mounting clips and replace if worn
• Refer to the washer's service manual or exploded parts diagram for correct removal and reassembly

This factory replacement generator assembly restores the proper electrical output for the specific circuit it supports in your appliance, helping the related feature operate as designed and preventing intermittent or failed operation.

• Generates the required electrical signal/output for its control circuit
• Helps ensure the associated feature starts and runs consistently
• Failure can cause that feature to not operate or to work intermittently
• Visual heat damage, corrosion, or a burnt odor near the module may be present

• Disconnect power to the appliance before servicing
• Access location per your model's service information; note wire routing and connector orientation
• Transfer any brackets or insulators from the original part if needed
• Secure connections and harnesses; test the feature after reassembly