Dispenser Parts

Fix washer detergent not dispensing or leaking from drawer. This dispenser box diverter assembly restores proper detergent flow in front-load washers.

Fix a cracked or broken dispenser drawer front that won't close properly or leaks detergent. Direct replacement part installs in 10-15 minutes.

This bleach dispenser box is the plastic reservoir that holds and directs liquid bleach into the washer during the wash cycle, helping the machine deliver bleach safely and evenly. Fits select GE top-load washers. What it does:

• Holds liquid bleach until the washer adds it at the correct time
• Directs bleach into the wash tub to prevent concentrated bleach contact with clothes
• Helps prevent leaks from the dispenser area when functioning properly
• Common symptom: cracked or warped box causing leaks or bleach not dispensing

• 1 bleach dispenser box

• Turn off power and shut off water supply before starting work
• Replace only with the exact part to ensure proper fit and sealing
• Inspect surrounding gaskets and hoses; replace if damaged to avoid leaks

Fix detergent leaking before wash starts or not dispensing properly. This washer dispenser cup holds liquid or powder detergent until the correct cycle phase.

Fix temperature imbalances between compartments with this refrigerator damper wheel. Controls airflow for consistent cooling. Simple DIY repair.

This replacement cover provides the protective housing for the related appliance component, keeping internal parts shielded from debris and helping maintain safe operation. It's a direct-fit exterior piece designed for easy swap-out. What it does:

• Shields internal components from dust, moisture and loose debris
• Helps maintain proper alignment and spacing of the enclosed parts
• Reduces risk of accidental contact with moving or electrical parts
• Restores the appliance's finished appearance where the original cover was damaged or missing

• One cover

• Disconnect power (and water, if applicable) before starting any repair
• Remove surrounding panels and fasteners to access the existing cover; retain screws for reuse unless new fasteners are provided
• Handle carefully to avoid damaging mounting tabs; test fit before final fastening

This dispenser drawer handle trim assembly replaces the trim and handle piece on the refrigerator dispenser drawer for a clean, finished look and reliable grip. It restores proper drawer operation and user access to the dispenser area. What it does:

• Replaces damaged, cracked, or worn dispenser drawer trim and handle for improved appearance
• Provides a secure grip to open and close the dispenser drawer smoothly
• Helps keep the dispenser opening sealed and aligned for normal drawer function
• Addresses visible cosmetic damage and loose or broken handle symptoms

• High-level replacement; typically requires removing the drawer or access panel—refer to your model's service diagram
• Disconnect power to the appliance before starting work to avoid injury
• Handle parts may snap or screw into place; save any retaining clips or screws from the old part for reuse

Replace a broken or cracked washer dispenser drawer that won't close properly or is leaking detergent. Includes drawer, handle, and trim components.

Fix your washer dispenser drawer issues with this frame component. Supports drawer assembly operation and magnet placement. Direct-fit part for repair.