General Electric Endcap Parts

This right-side end cap is the molded exterior trim piece that finishes the appliance cabinet and protects internal edges. It restores a clean, finished appearance and helps keep door and panel seams sealed from dirt and moisture. What it does:

• Covers and protects the outer edge on the right side of the cabinet, preventing exposure of internal components
• Restores a flush, factory-finish look when a cracked or missing end cap causes gaps or rough edges
• Helps maintain proper panel alignment and visual symmetry on the appliance exterior
• Reduces dirt and moisture intrusion where panels meet, supporting overall cabinet integrity

• One right-side end cap (white), as shown

• Designed for snap- or screw-fit installation; remove power and follow manufacturer disassembly steps before replacing
• Verify orientation (right side) and matching color before starting; handle trim pieces gently to avoid cracking
• Use basic hand tools; keep fasteners and any retainer clips for reuse or replace if damaged

This left end cap is a molded replacement trim piece that restores the finished edge and appearance of the appliance door. It replaces a cracked, broken or missing cap to keep the door trim secure and looking original. What it does:

• Covers and protects the left edge of the door trim or hinge/handle end for a finished appearance
• Hides mounting hardware and helps keep the trim aligned
• Prevents sharp edges or exposed holes that can catch on clothing
• Common symptom: visible crack, broken corner, loose or missing end cap causing an unfinished look

• Install with basic hand tools; verify orientation for the left side before fastening
• Handle parts carefully to avoid scratching the finish during installation
• Disconnect power only if needed to access components near wiring — otherwise follow normal appliance safety practices
• If mounting hardware is missing or damaged, replace only with manufacturer-recommended fasteners