Kitchenaid Parts

I ordered the gasket with the model number off the frig. AppliancePartPros.com made it easy to find my part. There was also a "how to" video on the same page. I ordered the part and it got to OH the next day. Following the video guideline it took me 15 minutes to remove the door, strip out the old seal and put in the new one. I will be ordering all my appliance parts from AppliamcePartsPros.com Read more

This KitchenAid Refrigerator was put into service in 2007. I thought it died 5 years ago when all it needed was a couple of days to defrost some ice build up in the walls between the freezer and refrigerator sections. At that time we bought a smaller new backup refrigerator thinking we'd also be needing a new main refrigerator, but it was really fine after the thaw out. So we kept it! Then, the other day, it just stopped cooling. I noticed food starting to get soft in the freezer, but the... Read more

Replacing a magnetron in my particular 9-year-old microwave (a microwave/hood combination) was not a simple “plug & play” operation. That is why I am placing this in the slightly difficult area. First, it takes 2 people to remove the microwave from the top of the stove. Next the main outer panel need to be removed. After that, 2 sheet metal panels need to be removed in order to expose the high voltage components for testing. Always discharge the high voltage capacitor first before doing... Read more

Removed existing gasket and replaced with new gasket in less than 5 minutes. Very Easy. Make sure to remove the lower burner cover (inside the oven) which allows you to pull the end gasket material through the two circular openings in the frame. Read more

Replaced with new part. 5 minutes. Read more

Checked and found the evaporator frozen causing the fan to stop working. Took the interior panels off and applied a blow dryer to the ice, once the ice melted I cut the tabs on the grommet holding the fan since everything is thin plastic and replaced the grommet and fan. Placed everything back and found no further issues. Tools I used were a small flat head screwdriver to pry the panels off and a 1/4 socket to remove the center drawer (4), water filter cover (2), and the ice maker (2). Not too... Read more

• Door won't open or close
• Door sweating
• Fridge too warm
• Clicking sound

Used floor jack to lift and secure door, left upper hinge point in place, removed lower hinge support, removed old cams and installed new ones and lubricated, secured and adjusted hinge . Read more

I searched the web for a replacement drawer to no avail. Once I reached this site I was pretty discouraged when your site also said my drawer was no longer available. A suggestion for a different replacement drawer that MAY work was my only option. I purchased the drawer with the understanding that it could be returned if it didn't fit. To my surprise it came in two days and fit perfectly. I am thrilled every time I open the fridge. I am VERY pleased with this purchase and would... Read more

• Won't start

Through 15 years of vibration, the Cycling Thermostat evidently had degraded to the point where one electrical connection or more came loose and caused a short. There is also a possibility that the Bakelite section of the Dryer Cycling Thermostat body separated from the metal base, simultaneously exposing all four connections to a short. The thermostat literally exploded into chunks and dust. There was a heavy arcing and then, thankfully, the thermal fuse blew and shut down power to the short... Read more

I can't believe that we lived with this shelf bar continually falling off for years due to a broken end cap. Easily found the replacement end cap on AppliancePartsPros for our 18 year old refrigerator. The "repair", if you can call it that, took perhaps 30 seconds -- remove old broken end cap, insert new one. Done. No more shelf bar falling off. One of life's little annoyances just went away. Read more

Bought a new lint screen housing and top flapper. Probably didn’t need the flapper but I didn’t want to set into the repair and find out I did need it. Read more

Disassembled and confirmed the clutch was bad. Also noticed a slight leak from the transmission shaft seal. Ordered replacement clutch, seal and oil from appliancepartspros.com. The parts arrived very quickly and exactly as ordered. Their repair videos were very accurate and made the job easy. I accomplished a quality repair at a reasonable cost. My thanks to the folks at appliancepartspros.com for making it possible! Read more

• Noisy

After having replaced the drum support rollers twice in a roughly 3yr period, I realized something wasn't quite right, and indeed it wasn't. I had been ordering the wrong parts - I did use the online parts locator after checking, & double checking my model number. Apparently my older Whirlpool dryer has a somewhat ambiguous model number because the rollers that were shipped each time looked nothing like the originals. I realize that is not particularily uncommon - manufacturers often modify... Read more

My son broke the bottom shelf on the refrigerator door. I found the model number inside the frig and within 5 mins the part was on it's way! Ordered it Saturday morning , and arrived on Monday! Too easy! Slipped right into place! Read more

Just slid it under the ice maker Read more

No tools needed. Whole dairy door slipped right in. Read more