Screws, Nuts, Washers

I removed the burners, which were rusted and needed some tapping.They were pretty stubborn to remove from the insert. I removed the spark igniters, which were rusted where they screwed into the burner and then removed the venturi tubes.. Once this was done, I installed the new igniters to the underside of the new burner. I then installed the burners, which only took simple placement and a quarter turn to lock them in. I then hooked up the igniter wire to the new spark igniters. The repair... Read more

1) Unscrewed the metal pieces behind the switch panel. You'll notice 3 screws. Afterwards, I realized that I just needed to remove the screws to the left and right of the switch box. The box then slides out. If you take out the third that connects the box to the wire cover, just remember to screw that back in before you replace the box. 2) To make sure I didn't place the wiring in the wrong place, I basically took the wiring out one by one and placing it into the new switch. 3) Place the new... Read more

The screw that holds the agitator in place appeared to have worn and rusty threads. I tried to replace it with a standard hardware store 1/4-20 hex head screw but that wouldn't grip. I had thoughts of needing to tap the hole,but eventually bought the specified screw, which is a specialist. It has tapered threads, a shoulder, rubber bushings, an attached washer and a hex head. I spent a lot of time trying other things but when the real part arrived it only took a few minutes to set it in place. ... Read more

Ordered the screws needed from your website and put the doors back on the frig. Read more

I ordered two new baffles and 7 screws. I also ordered 6 large washers. We were running with one baffle held by only 2 of 3 screws. It appears that a repairman in the past had removed the large washers and over time, the screw heads reamed out the hole, causing the baffles to detach and break. In about 15 minutes, I was able to tighten up the existing baffle and add the two new ones. I also added the 6 big washers to help strengthen this to prevent future issues. I no longer have to listen to... Read more

Replaced roller. Read more

I ordered the part and was impressed to receive it within two day! I didn't need the screws I ordered (which I ordered just in case) but the trim was put on with no problem and my oven looks brand new again! Thank you! Read more

I ordered the parts needed to replace the end cap unit. On the website, there was a video showing you how to replace the parts. I followed the video and it was very easy. I would say it took longer than I anticipated but that is because I cleaned the unit. Had I not cleaned the fridge, it would have been less than 1/2 hour. Read more

Removed the microwave from the upper cabinet, then (partially) removed the black cover. We were able to access and remove the old mounting nut from inside the unit, and clip on the new one! Read more

I was very pleased to get the glass on time and it was a perfect match. The only thing I had trouble was to get the screws required to fix. The screws were not available, so spend too much time trying find equivalent screws in homedepot. Read more