Need Help?
Call or text
Replacement drain hose assembly for washers. Carries wastewater from washer to household drain. Replace if cracked, kinked, split, or leaking.
I searched for parts on the internet regarding the make and model of my washer. Appliance Parts Pros not only had the part on a very user friendly website, but also had a well done video that made fixing the problem a breeze. Much appreciated and will buy from here from now on. Highly recommend! My local parts store did not have the part and would have to order it anyway. Read more
The Drain Hose is an OEM replacement part for Whirlpool washing machines. It connects the washer tub to the drain pipe, facilitating the drainage of water after a wash cycle is complete.
Causes of a bad drain hose can include regular wear
This hose did not just attach to the back of the washer--that would have been too easy. This hose went into the back of the washer, under the tub & attached to the pump at the front of the washer. Both the back & front of the washer had to be removed to access the hose. Luckily the crack was at an external spot where it was easily seen; unluckily my husband was out of town at the time & I had to take the washer apart & put it back together. Actually it was not that hard. Before I took the... Read more
The Pump Hose is an OEM replacement part for LG washing machines. It is a flexible tube that connects the pump assembly to the internal tub and spins through the detergent dispenser area. The pump hose is responsible for circulating and removing water
REMOVED BACK PANEL, USED PLYERS TO REMOVE CLAMP, PULLED OLD HOSE OFF, REVERSED PROCEDURE TO INSTALL NEW HOSE. TOTAL TIME ABOUT 10 MINUTES. Read more
Connects the outer tub to the drain pump in front-load washers. Replace if cracked, torn, leaking, or clogged to stop water damage and restore drainage.
Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove... Read more
Replaces broken or cracked siphon break assembly on your washer. Installs on back panel where drain hose connects. Needed when elbow becomes brittle.
Ordered Siphon Break Kit. Speedy shipping, thank you. Attached video shows how to remove front of washer to access screws to loosen top of washer to access siphon break from inside washer cabinet. http://www.do-it-yourself-washing-machine-and-dryer-repair-help.com/siphon-break-Maytagwasher.html Read more
Drain hose assembly connects your washer tub to the household drain. Replace if cracked, kinked, leaking at connections, or worn from age and use.
Replaced Drain Pump. Also replaced worn drain hose, recirculation pump, and tub drain hose since I had the entire machine taken apart. Wash Machine only 3 years old. Interesting since the error was intermittent. Read more
Replacement drain hose directs used water from your washer to the household drain. Needed when original hose is cracked, split, or leaking.
Our washer is next door the bathroom. So when, during the rinse cycle, the hose split and we found the back of the house completely flooded I initially assumed the culprit was either the toilet or the sink or possibly an interdimentional portal into a demonic netherworld of vaguely chlorine scented water. I spent the next hour mopping it all up and checking and re-checking the pipes in the bathroom with no apparent leaks. The next load of laundry left more clues as this time the flood was from... Read more
Directs water from inlet valve to detergent dispenser in LG washers. Replace if hose is cracked, leaking, won't stay attached, or damaged from wear.
I figured after 10.5 years that it might be time to replace the dispenser hoses because I was noticing black stuff in the dispenser trays. I replaced two or the four hoses and clamps on the far left side and for good measure the hot water inlet valve. The inlet valve was okay but the screen had all kinds of crap in there that I couldn't clean out so now I have an extra solenoid just in case one of the others fails. While I was at it I removed the dispenser and cleaned the calcium build up on... Read more
Connects portable dishwasher hose to kitchen faucet. Replace if cracked, worn, or threads are stripped causing loose connection or leaks at sink.
SCREWED IT ONTO FAUCET Read more
Carries wastewater from washer pump to household drain. Replace if cracked, leaking, clogged, or damaged to restore proper drainage and prevent puddles.
Replaced the drain pump and the drain hose (since I was replacing the drain pump). The new drain pump seems to pump out the water more forcefully than the one replaced. Have not received a LD code during the wash cycle since the replacement was installed. Read more
Flexible drain hose connecting the washer tub to the pump. Replace if cracked, punctured, or torn. Installs behind the service panel with spring clamps.
Our washing machine door boot seal was getting moldy and causing odor problems. Cleaning tablets and bleach weren't helping so it was time to be replaced. While I had the top and front off I changed all the hoses that could be collecting soap scum and mold, all other wetted parts were removed and washed. The video on the door boot seal, and inlet valve assembly were extremely helpful in understanding how these parts are removed and reassembled. Although the door boot seal is the most visible... Read more
The Pressure Switch Hose is an OEM part for Whirlpool washing machines. This hose connects the pressure switch to the washer tub, allowing the machine to detect water levels and ensure proper operation of the washing cycle.
Common causes of dam
After watching a number of videos and reading a lot of trouble-shooting discussions online I had ideas of what to look for as possible causes of the overfilling of the drum. I found the water level pressure hose had worn through after contacting the rotor. After temporarily taping the hose, I found the service manual inside the machine so I ran it through it test sequences without any error codes. Suggesting the hose and not the sensor or inlet valves were the problem. I ordered parts last... Read more
Replace a cracked, leaking, or worn washer drain hose. 48 inches long with clamp included. Installs between pump and standpipe for proper drainage.
Ordered a new drain hose and extension part. The prices including shipping were more reasonable than driving back and forth to the store just to piece meal parts together. Very frustrating. I ordered the parts that were specific to our washing machine, it took maybe 5 minutes to install, and everything fit perfectly. Now we're washing again and no leaks! Read more
Internal drain hose channels water from washer tub to external drain system. Replace if cracked, kinked, or leaking to restore proper drainage function.
Replacement water fill hoses for washing machines. Connect home water supply to washer. Replace when cracked, leaking, or showing rubber wear or corrosion.
Motor control board was flashing 4 times, indicating that the mode shifter had an error. I disconnected the mode shifter's wire from the controller and measured the resistance between the 2 leads with an ohmmeter. Since the reading was infinite, that meant that the mode shifter coil or in-line thermal sensor was electrically open, i.e. bad. As this fix is near a complete tear-down of the washing machine, here are a few tips I discovered. 1) the hub nut is difficult to remove and you need a... Read more
The Hose Assembly & Connector is an OEM part for LG washing machines. This assembly includes the hose and connector, which are essential for supplying water to the washer during operation, ensuring a steady and reliable flow.
Causes of a ba
Checked all hoses for clogs cleaned them out and problem still existed so it was time for a new pump and since I was in there I replaced the drain hoses as well. Pump and hoses were exact oem replacement parts project took 30 minutes and the wife was happy again!!! Read more