Cap Or Cover

This is a small adhesive label or cover designed to conceal unused hinge mounting holes on the appliance door, providing a clean finished appearance. It is white in color and covers the hole left when the door hinge is installed on the opposite side. Replace if the cover is peeling, missing, or discolored, leaving an exposed hole on the door surface.

Plastic cover that shields the water inlet valve assembly on the back of your refrigerator. Replace if cracked, broken, or missing to protect wiring.

The left hinge cover assembly is the decorative plastic cap that snaps over the upper or lower left door hinge on your refrigerator, concealing the hinge hardware for a clean finished look. It also helps protect the hinge mechanism from dust and damage. Replace this part if the existing cover is cracked, broken, or has gone missing, leaving the hinge hardware exposed.

Replacement lid for glass coffee carafe in onyx black. Essential when your original lid is cracked, broken, missing, or no longer seals properly.

Replacement hinge cover cap for refrigerator door. Restores finished appearance after door reversal or replaces cracked, broken, or missing covers.

Replace your refrigerator's damaged or missing cover cap. This protective cover installs over internal components to restore a finished appearance.

This is a grey plastic hinge cover that snaps over the left hinge assembly on the top or bottom of a refrigerator door. It conceals the hinge hardware for a clean, finished appearance. Replace this cover if it is cracked, discolored, or missing, which can leave the hinge exposed to dust and moisture.

Protective cover for your dryer's terminal block electrical connections. Replace if cracked, broken, or missing to safely cover wire terminals.

Rear cabinet cover panel for washers. Encloses the back of the washer cabinet. Replace if cracked, damaged, or missing to restore appearance.

The washer cap handle screw secures the handle cap to the washer door or lid handle assembly. Replace when the handle feels loose, the cap falls off, or the screw is stripped or missing.

Black chevron-style top trim cap for refrigerator upper control area. Replace cracked, chipped, or faded trim to restore front appearance and finish.

This white cover hinge replaces a worn or broken hinge that supports and pivots the appliance cover, restoring proper alignment and smooth opening/closing for the lid. Designed as a direct-fit replacement where specified. What it does:

• Provides a secure pivot point so the cover or lid opens and closes smoothly
• Keeps the cover aligned to prevent sagging, rubbing, or binding
• Restores a proper seal/closure when hinge wear causes gaps or misalignment
• Helps eliminate rattling or excess play caused by a damaged hinge

• Disconnect power (and water if applicable) before starting any repair.
• Handle the lid/cover carefully during removal to avoid dropping or injury.
• Basic hand tools are typically required; follow your model's service diagram for location and fastener details.
• Replace with the same OEM part number to ensure fit.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

Right-hand cap cover for refrigerator compartments. Replaces cracked, broken, or missing covers. Snaps into place on right side panels or shelves.