Cap Or Cover

Replace your refrigerator's damaged or missing cover cap. This protective cover installs over internal components to restore a finished appearance.

This is a grey plastic hinge cover that snaps over the left hinge assembly on the top or bottom of a refrigerator door. It conceals the hinge hardware for a clean, finished appearance. Replace this cover if it is cracked, discolored, or missing, which can leave the hinge exposed to dust and moisture.

Protective cover for your dryer's terminal block electrical connections. Replace if cracked, broken, or missing to safely cover wire terminals.

Rear cabinet cover panel for washers. Encloses the back of the washer cabinet. Replace if cracked, damaged, or missing to restore appearance.

The washer cap handle screw secures the handle cap to the washer door or lid handle assembly. Replace when the handle feels loose, the cap falls off, or the screw is stripped or missing.

Black chevron-style top trim cap for refrigerator upper control area. Replace cracked, chipped, or faded trim to restore front appearance and finish.

This white cover hinge replaces a worn or broken hinge that supports and pivots the appliance cover, restoring proper alignment and smooth opening/closing for the lid. Designed as a direct-fit replacement where specified. What it does:

• Provides a secure pivot point so the cover or lid opens and closes smoothly
• Keeps the cover aligned to prevent sagging, rubbing, or binding
• Restores a proper seal/closure when hinge wear causes gaps or misalignment
• Helps eliminate rattling or excess play caused by a damaged hinge

• Disconnect power (and water if applicable) before starting any repair.
• Handle the lid/cover carefully during removal to avoid dropping or injury.
• Basic hand tools are typically required; follow your model's service diagram for location and fastener details.
• Replace with the same OEM part number to ensure fit.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

Right-hand cap cover for refrigerator compartments. Replaces cracked, broken, or missing covers. Snaps into place on right side panels or shelves.

Protective cover cap for refrigerator temperature sensor. Snaps into place to shield sensor from damage. Replace if cracked, broken, or missing.

White plastic cover cap that conceals mullion screws in your refrigerator. Replaces cracked, broken, or missing screw covers for a finished appearance.

White plastic end cap for refrigerator front grille assembly. Replaces missing, cracked, or broken grille caps. Snaps onto grille edge for clean finish.

Black plastic grille end cap for refrigerator base grilles. Replaces broken, cracked, or missing caps that secure grille panels at the edges.

This plastic hinge cover installs on your refrigerator door to conceal the hinge mechanism. Replace if cracked, broken, or missing for a complete look.

Protects the auger motor and gearbox in your refrigerator's ice dispenser. Replace if cracked, broken, or missing to keep debris out and ensure proper ice flow.

Sliding cap for refrigerator shelf frames. Replaces broken, cracked, or missing caps on glass shelf assemblies. Installs on shelf frame edges.