Cap Or Cover

Access panel cover for refrigerators. Protects internal components from dust and debris. Replace if cracked, broken, or missing to maintain safety.

Replacement cover for the refrigerator dispenser bucket opening. Restores a cracked, broken, or missing cover to contain ice and improve appearance.

Covers and protects the upper door hinge area on your refrigerator. Replace this plastic cap if cracked, broken, or missing to restore a clean look.

Front access panel that covers internal components at the base of your refrigerator. Replaces cracked, dented, or missing lower covers.

Covers and protects the upper door hinge on your refrigerator. Replace if cracked, broken, or missing to restore a finished look and shield the hinge.

Protective cover for water valves and inlet hoses. Replace if cracked, broken, or missing to shield components from debris and accidental contact.

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.

Replacement access cover panel for refrigerators. Closes service openings and protects internal components. Needed when original is cracked or missing.

A replacement cover motor that powers the refrigerator's dispenser cover, allowing the door to open and close so you can access ice and water. Replaces a worn or failed motor to restore normal dispenser cover operation. What it does:

• Drives the dispenser cover mechanism so the cover opens when dispensing and closes when idle
• Helps keep the dispenser sealed to reduce drafts and prevent pests or debris from entering
• Stops or fails to move when worn, causing a stuck, slow, or noisy dispenser cover
• Works with the dispenser linkage and gears to coordinate cover motion with user controls

What's included:

• One cover motor

Install notes:

• Disconnect power to the appliance before beginning any repair
• Remove dispenser trim and access panel per your model's service instructions to reach the motor
• Handle gears and linkage carefully; ensure proper alignment during reassembly and test cover operation before finishing

This is a cover or overlay that fits over the dispenser drawer handle area on a washer dryer combo unit. It provides a finished appearance and protects the underlying components of the detergent or fabric softener dispenser. Replace it if the cover is cracked, discolored, broken, or missing, which can make the dispenser difficult to open or detract from the appliance's appearance.

This is a plastic cover that fits over the left-hand pantry rail inside the refrigerator compartment. It provides a finished appearance and helps secure the pantry shelf or drawer rail in place. Replace it if the cover is cracked, broken, or missing, which can cause the shelf or drawer to feel loose or unstable.

Plastic cover that conceals and protects water supply tubing behind the lower kickplate. Replace if cracked, broken, or missing for a finished look.

Protective cover for the refrigerator thermistor sensor. Replace if cracked, broken, or missing to protect the temperature sensing component.

Plastic cover cap that conceals and protects wire connections in your refrigerator. Replace if cracked, broken, or missing for a clean finish.