General Electric Chassis Or Cabinet

Replace your oven's front frame if it's cracked, bent, or damaged. This structural component mounts around the control panel and door opening.

A replacement left cover that restores the exterior finish and protects internal components on the appliance. Fits where the factory left side panel was damaged, cracked, dented, or removed for service. What it does

• Covers and protects wiring, controls and internal parts on the appliance's left side
• Restores the appliance's appearance after impact or wear
• Helps stop drafts, rattles, and exposure caused by a missing or damaged panel
• Maintains proper clearance and helps keep debris out of internal compartments

• One left cover

• Disconnect power (unplug or switch off breaker) before starting repair
• Remove adjacent trim or access panels as needed to reach mounting screws
• Handle edges carefully to avoid cuts; use gloves if possible
• Tighten fasteners securely but avoid overtightening which can deform the panel

This large base plate is a replacement mounting panel that supports and secures lower components in the appliance, restoring proper alignment and stability for the cabinet floor area. What it does

• Serves as a structural mounting surface for lower-range/oven components and assemblies
• Helps keep internal parts aligned and prevents unwanted shifting or sagging
• Worn or damaged base plates can allow vibration or rubbing that can cause noise or poor fit between panels
• Replacing a distorted or corroded plate restores secure fastening points and cabinet integrity

• One large base plate

• Disconnect power (and gas if applicable) before starting any repair
• Follow the appliance's service manual or diagram for correct orientation and fastener locations
• Use appropriate hand tools; avoid overtightening fasteners which can warp the plate
• Wear gloves to protect against sharp sheet-metal edges and reinstall any removed insulation or hardware

Black bottom base panel for microwave chassis. Replaces cracked, broken, or missing base. Structural support component for cabinet assembly.