General Electric Trim

This stainless steel lower trim piece finishes and protects the bottom edge of the appliance door or opening, restoring appearance and sealing the lower edge. It fits where the factory lower trim was damaged or missing. What it does:

• Covers and protects the lower front edge from dings, scratches and wear
• Restores a clean, finished look to the appliance front
• Helps maintain proper door alignment and edge coverage when installed correctly
• Commonly replaced when the trim is dented, bent, corroded or missing

• Turn off power to the appliance and ensure the area is cool before beginning
• Removal/installation typically requires basic hand tools; handle trim carefully to avoid scratching
• Align trim with mounting tabs or screw holes and secure per factory fasteners

This barrier door is the inner door shield that protects the oven/microwave cavity and helps ensure the door latches and seals correctly for safe operation. It replaces a damaged or warped barrier that can affect door closure and performance. What it does:

• Shields the control area and cabinet from heat, steam, and food debris inside the cavity
• Helps the door latch engage and maintain a proper seal for normal operation
• Restores correct door alignment when a bent or cracked barrier prevents full closure
• Can reduce unusual noises or rubbing caused by a damaged inner door panel

• One replacement barrier door

• Disconnect power before starting; appliances can store lethal voltage even when unplugged
• Handle panels carefully to avoid sharp edges and damaging the finish
• Verify correct orientation and engage all door clips or screws securely during reassembly

This trim vent assembly replaces the front vent trim on compatible ranges to restore proper airflow appearance and prevent debris from entering the vent area. It provides a finished look and helps direct heat and air safely away from the control area. What it does:

• Covers and protects the range vent opening while maintaining proper airflow
• Helps reduce dust and debris entry into the vent channel
• Restores the factory appearance of the range front after damage or wear
• Common symptom: visible damage, cracks, or loose/missing vent trim

• Disconnect power (and gas supply if applicable) before starting any repair
• Basic hand tools are typically required; follow OEM disassembly order for safe access
• Handle trim carefully to avoid scratching the finish; fasten securely to prevent rattling

This lower front frame panel restores the look and protective trim at the base of the appliance door, replacing cracked or damaged front-frame trim to improve appearance and secure adjacent parts. Fits the factory white finish. What it does

• Replaces a cracked, chipped or broken lower front frame panel that makes the door look worn
• Covers and protects underlying components and mounting points at the door base
• Helps align the door edge and retain adjacent trim pieces
• Restores a clean, factory white appearance to the appliance front

• One lower front frame panel — white

• Disconnect power to the appliance before beginning any repair
• Remove any decorative trim or screws blocking access; panel typically secures with clips and/or screws
• Handle the replacement panel carefully to avoid scratching the finish and to seat clips fully