Housing Or Cover

This is a left-side cover or shroud that sits over the magnetron area inside the oven cavity. It helps direct airflow and protect internal components from grease and debris. Replace this cover if it is cracked, warped, or damaged, which can lead to uneven heating or exposure of sensitive parts.

Control box housing for refrigerators. Mounts at the front top of the fresh food compartment. Replace if cracked, broken, or damaged housing.

Control box housing cover for refrigerators. Mounts to upper cabinet and secures control assembly. Replace if cracked, broken, or missing tabs prevent proper fit.

Front housing cover for refrigerator control box assembly. Mounts in food compartment with light and damper. Replace if cracked, broken, or damaged.

Replace your cracked or broken range valve cover. This protective housing installs over the gas valve assembly to shield internal components from damage.

This electronic control board manages a refrigerator's user interface and internal functions so the appliance responds to settings and maintains proper operation. Replaces a failed control box to restore control and electronic communication. What it does:

• Controls display, touchpad/controls, and status lights
• Manages compressor, fans and defrost cycles via relay/logic signals
• Communicates sensor inputs to regulate temperatures
• Can cause blank display, unresponsive controls, or intermittent operation when failed
• Stop normal cooling or defrost functions when electronics malfunction

• Disconnect power at the breaker or unplug the appliance before starting
• Take a photo of wiring/harness positions before disconnecting to ensure correct reassembly
• Handle the board by edges and avoid static discharge; use an anti-static wrist strap if available

Replace your washer dryer combo's damaged or cracked housing cover. This protective cover installs on the exterior to restore your appliance's appearance.

Replace your refrigerator's control housing cover if cracked, broken, or missing. This protective cover installs over the control panel assembly.

This lower interior light housing assembly replaces a cracked or damaged refrigerator lower light housing and restores the light fixture mounting and lens for proper illumination of the fresh-food compartment. What it does:

• Replaces the lower interior light housing and lens assembly to secure the light and lens in place
• Restores proper alignment and protection for the lower refrigerator light
• Helps stop rattling or movement caused by a broken housing
• Addresses symptoms like a loose or missing lens, exposed bulb, or improper light positioning

• One lower interior light housing assembly (housing with lens as shown)

• Disconnect power to the appliance before starting any repair
• Remove the existing housing carefully to avoid damaging the bulb or wiring
• Retain or reuse the original bulb unless explicitly replacing it
• Use proper fasteners and alignment tabs;

Replacement evaporator shroud for refrigerators. Directs airflow around the evaporator and fan assembly. Needed when original is cracked or damaged.