Housing Or Cover

This is an H-shaped edge connector used in the dryer's power control housing area. It provides an electrical connection point between wiring harnesses or circuit boards within the control section of the dryer. Replace this connector if you notice intermittent dryer operation, loose wiring connections, or visible damage such as burnt or corroded terminals.

Molded access cover that houses and protects the washer pump and plumbing. Replace if cracked, broken, or missing to restore factory protection.

Protective housing that encloses the washer pump area. Replace if cracked, broken, or missing to restore proper coverage around the drain pump assembly.

Bottom housing for washer diverter box assembly. Replaces cracked, broken, or damaged diverter box bottom cover. Installs on water distribution system.

Replacement diverter box top cover for washers. Directs water flow to upper spray components. Replace if cracked, broken, or leaking. Restores proper operation.

White plastic housing that secures the dispenser meter assembly in your washer. Replace if cracked, broken, or missing to restore proper alignment.

Electric controller box housing for room air conditioners. Replaces cracked, broken, or missing electrical component enclosures. Protects wiring.

Replace your air conditioner's temperature control cover when the original is cracked, broken, or missing. Shields the control opening and supports knob.

Rear clapboard cover for air conditioners. Replaces cracked, broken, or missing exterior housing panels. Restores cabinet appearance and protection.

Replace a cracked or broken control box housing on your air conditioner. This protective cover secures internal electrical components and wiring.

Replace your air conditioner's condenser shroud if cracked, broken, or missing. This protective housing cover installs over the condenser unit exterior.

Replacement control box housing for air conditioners. Protects electrical components and wiring. Order a new housing if yours is cracked or damaged.

Protective housing cover for air conditioner condenser unit. Installs around exterior coil assembly. Replace if cracked, broken, or missing.

Replacement shroud cover for air conditioner units. Protects internal components from debris and weather. Needed when original is cracked or damaged.

Secures and positions the motor inside your air conditioner. Replace this bracket if it's bent, cracked, or causing excessive vibration and misalignment.

Complete outer housing for room air conditioners. Replaces cracked, dented, or rusted cabinets. Encases internal components for protection.