Fuse Or Sensor

Microwave won't power on or display anything? A failed thermostat is often the cause. This part regulates temperature to prevent overheating. DIY fix.

Dryer not heating or won't start? This thermal fuse and thermostat kit restores safety protection and proper temperature control in your dryer.

Oven won't heat or stops mid-cycle? A blown thermal fuse cuts power when temperatures exceed safe limits. This part restores heating and protection.

Oven won't heat or trips during self-clean? This limit switch cuts power when temperature exceeds safe limits. Simple plug-in installation in 30 minutes.

Fix dishwasher not heating or filling issues with a new sump thermistor. This sensor regulates water temperature for optimal cleaning performance.

If your air conditioner won't power on or has no display, a blown fuse may be the cause. This fuse protects the electrical circuit from surges and shorts.

Air conditioner won't turn on or suddenly stops working? A blown electrical fuse is often the cause. This fuse protects your unit's circuitry.

Ceramic

Microwave won't start or stops mid-cycle? A blown fuse is often the culprit. This 5 amp fuse protects your microwave's electrical system. Quick DIY fix.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dryer won't start or stops mid-cycle? A blown thermal fuse is often the cause. This safety component cuts power when temperatures get too high.

Range won't heat or shuts off unexpectedly? A faulty thermal fuse may be the cause. This safety component protects against overheating. DIY repair.