Cap Or Cover

Protective cover for the fuse and terminal block in your laundry center. Replace if cracked, broken, or missing to shield electrical connections.

Houses and protects the evaporator coil in your refrigerator. Replace this cover if cracked, broken, or missing to restore proper airflow and drainage.

Restores the finished edge on your refrigerator cabinet and hides gaps. Replaces cracked, broken, or missing corner trim for a cleaner appearance.

Replacement cap for washer softener and bleach dispenser. Seals dispenser opening to prevent spills and contamination. Needed when original cap is cracked or missing.

Refrigerator door shelf cover that snaps onto door bin rails. Replace this plastic cover if cracked, broken, or missing to restore a clean appearance.

Replacement clip cover that snaps over mounting clips to conceal hardware on your washer dryer combo. Restores finished appearance when original is cracked or missing.

Allows water dispenser and ice maker to operate without a filter installed. Replace when damaged or missing to restore water flow. Verify fit by model.

Plastic housing trim that protects the evaporator coil in your freezer compartment. Replace if your cover is cracked, broken, worn, or missing.

Replacement access cover that restores your refrigerator's finished look while protecting internal components. Needed when original is cracked or missing.

Replaces the worn, cracked, or missing cap that covers the fabric softener chamber in your washer dispenser. Restores proper containment and function.

White button plug cap for refrigerators. Covers screw holes or mounting points on control panels and exterior surfaces. Replace when missing, cracked, or discolored.

Black hinge cover for side-by-side refrigerators. Replaces cracked, broken, or missing covers where the hinge mounts to restore proper fit and appearance.

This is a panel that covers the compressor compartment, typically located at the bottom rear of the refrigerator. It protects the compressor, condenser coils, and related components from dust and debris while allowing access for maintenance. Replace this cover if it is cracked, broken, or missing to keep the compressor area properly enclosed and protected.

Grey plastic hole plug cap for refrigerators. Covers unused mounting holes in cabinet interior or shelving. Replace if original is cracked, missing, or broken.

This grille sensor is the temperature-sensing probe that monitors heat in the appliance grille area to help controls regulate cooking temperature and safety features. It provides accurate feedback so the oven or grill can maintain set temperatures. What it does:

• Senses temperature in the grille/grill area and sends readings to the control board
• Helps the appliance maintain consistent cooking or broiling temperatures
• Can cause temperature-related errors or inconsistent heating when failed
• Common symptom: oven or broil function runs too hot, too cool, or shows error codes related to temperature sensing

• One grille sensor

• Disconnect power to the appliance before any service to avoid shock or injury
• Handle the sensor carefully; avoid bending or contaminating the sensing tip
• Route and secure the sensor wiring as OEM designed to prevent heat or pinch damage

Replacement blender lid with removable center insert. Seals the blender top to contain ingredients during blending. Needed when original is cracked or missing.