Clip Or Clamp

Secure dryer hose clamp prevents air leaks and improves venting efficiency. Replace if loose, damaged, or during hose maintenance. Confirm fit with model.

This small terminal pin connects a wire to an appliance's electrical terminal, restoring a secure electrical connection so components receive reliable power and operation. Ideal for repairing loose or damaged wire terminations. What it does:

• Provides a secure metal contact point for a wire at a terminal or connector
• Restores proper electrical continuity when a terminal end is worn, bent, or broken
• Helps eliminate intermittent power, arcing, or component failures caused by poor connections
• Used wherever a single-pin wire termination is required on the appliance harness

• Disconnect power before servicing to avoid shock or injury
• Remove the damaged terminal and ensure the replacement pin matches shape and size
• Crimp or seat the pin per OEM guidance; ensure a snug, corrosion-free connection
• If wiring or harness insulation is damaged, replace the harness

Secures and organizes wiring harnesses inside your dryer. Replace if wires are loose, vibrating, or damaged. Confirm fit with your model number.

A small metal C-shaped retaining clip that secures shafts, pins or components in place to prevent unwanted movement. Simple, durable hardware that restores proper fit and alignment for the part it secures. What it does:

• Holds shafts, pins or rods in position to prevent axial movement or disengagement
• Restores secure attachment where a worn or missing clip allows parts to shift or fall out
• Used in moving assemblies to maintain alignment and proper function
• Fits in a groove or slot and provides spring tension for a tight hold

• One C-clip (retaining clip)

• Inspect the mating groove/pin for burrs or damage before installing the clip
• Use appropriate snap-ring or pliers to compress/expand the clip as needed; wear eye protection
• Ensure the clip fully seats in its groove and that the retained component moves as intended

Secures hoses to fittings in washers and other appliances to prevent leaks. Replace when clamps lose grip or show corrosion. Confirm fit with your model.

Replacement clip that secures trim, panels, or small components to restore proper fit and reduce rattling and vibration. Install when a worn or missing clip leaves trim or panels loose or causes intermittent noise. What it does:

• Holds trim, panels or small assemblies in place to prevent movement
• Stops rattling and vibration caused by loose parts
• Replaces broken or missing clips that allow gaps or misalignment
• Small, snap-in retainer shaped to match original attachment point

• Always disconnect power before servicing the appliance
• Access the clip location by removing the adjacent panel or trim per the OEM diagram
• Clip typically snaps into place; use needle-nose pliers or a flat screwdriver to remove the old clip if needed

Secures washer hoses to connections preventing leaks and detachment during operation. Replace when clamps become worn or loose. Verify fit with your model.

A small metal retaining clip that secures a bi-metal thermostat or temperature sensor in place, helping maintain proper contact and accurate temperature sensing for reliable appliance operation. Simple, durable replacement part. What it does

• Holds a bi-metal thermostat or temperature sensor firmly against its mounting point or probe.
• Maintains consistent contact to support accurate temperature sensing and control.
• Can help stop intermittent temperature-related issues caused by a loose or damaged clip.
• Designed for direct replacement where a spring-style or formed metal retainer is required.

• One bi-metal retaining clip (single clip).

• Disconnect power to the appliance before attempting any repair.
• Removal/installation typically requires small pliers or a flat screwdriver; avoid excessive force to prevent damage.
• Verify clip orientation and that the sensor/thermostat is seated fully before securing.

Secures compactor panels and trim to the cabinet frame. Replace when mounting hardware is worn, broken, or causing rattling. Confirm fit with your model.