Dishwasher Parts

Turn off the power , pull dishwasher and replaced the new one . It is working now Read more

Replaced all movable parts. Read more

• lights flashing or blinking
• Noisy

This was a 5 min job after I watched a video on YouTube Any one can do this Read more

As a homeowner, I love that I can just type my model number into Appliance Parts Pros website and find a listing/diagram of the entire unit. So when my dispenser on my dishwasher broke, I just ordered a new one. I use You Tube to watch videos on the specific repair, and then VOILA! I do the repair myself, saving at least a hundred dollars in a repair persons service call charge! While this repair was for my dishwasher, I've also fixed my washing machine, dryer, and steam humidifier. Read more

Replaced door lower seal and door gasket. Read more

Instructions were on line. It was a quick easy fix. Read more

Just followed the helpful video on or linked to the site. Read more

• Door latch failure

After finding the model number for my dishwasher, I looked on line for the part and ordered it. The part arrived next day. I was a little hesitant to tackle it myself, as I am a 67 year old female. However I decided I could do it and was all set until I found out that I needed a Torx screwdriver. This however was not going to stop me. At a trip to my neighbor I was able to find bit for a drill that would let me remove one screw. The next stop was to my favorite hardware store where I... Read more

• Will not dispense detergent

Bought the replacement dispenser from APPros.com (of course). The video shows a front control panel, and our dishwasher has the 'hidden' control panel on the top of the door. So here's the difference: 1) You need to take out all the screws, except the two near the latch at the top. The other video shows only taking out the bottom six screws because the remainder of the screws hold the front control panel. I used a couple paint cans with rags on top to hold the corners of the door when... Read more

This was a dishwasher swap out. I first turned the water off to the inlet hose of the dishwasher from underneath the sink. Removed the inlet water hose from sink to dishwasher. (use wrench or adjustable wrench) Then removed the screws securing old dishwasher from the cabinetry. I then pulled out the dishwasher from the cabinetry hole it was in. I unplugged the power cord from the wall of the old dishwasher. Then Ii removed the other end of inlet hose still attached to old DW (braided stainless... Read more

I bumped into my KitchenAid dishwasher and the upper rack adjuster cracked. There was already a crack on the notch of the housing where the handle (lever) sits. In addition, the positioner popped out and I couldn't find it. So, I bought the three parts from AppliancePartsPros online. It arrived in about a week. The repair was fairly simple, but it still took about 45 minutes because I didn't want to crack the assemblies. For the housing, use a small slotted screwdriver to carefully... Read more

I am 72 years old. I appreciate my dishwasher, especially during the Holidays when we have lots of company. The bottom spray arm in my Amana dishwasher was not snapped into place and it ended up on the heating element...needless to say, it fried two holes in the spray arm and from that day on, it did not function as planned. I ordered the part from AppliancePartsPro.com and the new arm arrived as promised. It was well packaged and a perfect fit. I am so pleased and I know when I need parts... Read more

I found a YouTube video on how to diagnose the problem and a recommendation to buy the part with you guys. Read more

I looked at the diagram on Appliance Parts Pros and found the part that was broken and I added it to my cart. I realized that they also had the gasket that goes around the door and remembered that it leaks sometimes, so I put that in my cart as well. My wife reminded me that the hinge on the right side was rusty so I added that to my cart. For just over $1 with tax and shipping I was able to refurbish our dishwasher for less than 10% of what it would cost to replace. I watched a few YouTube... Read more

Order parts and replace. When removing attachments, do them one at a time and install them on new rack as you go. Watch for the small release tabs on the attachments (baskets, rollers and tine holders), "gently" put pressure to release; remember these units have been in hot water and they are brittle. Read more

I ordreded the tine clip kit. APPros was the least expensive, even with the shipping charge, and I had it in two days. Replacement piece snapped into place with very little difficulty. I also have extras from the kit so I am set if another breaks. Read more