Frigidaire Control Board

I watched YouTube videos for two days. I figured out it was the inverter board.I replaced the inverter board and it worked !!! I had to buy a meter to make sure the compressor was still good before I ordered the part. Read more

Replaced electronic control board and everything is back to working normally. Read more

Replace control board. Read more

The parts I ordered from you worked and got hereon time, great job, and thanks again. I will. use you again in the future Thanks again Read more

Replace control/switch panel along with exterior push button panel. Read more

Replaced the user interface panel. Four screws and 3 idiot proof wired connections. Hardest part was pulling the fridge out from the wall to unplug it before the swapping part. Read more

I replaced the defrost thermostat and the defrost timer. That corrected the problem. Be careful when ordering your parts. I put in my model# and they gave me a defrost timer that was incorrect. I had to return at my cost and order the correct one. Don't assume because you put in your model# that the part is correct. On each part there is a box to put in your model# to check to see if it fits your model. Don't assume that because you put your model# in before that it fits. If not sure, call them... Read more

I googled the error code and symptoms my oven was exhibiting to determine the solution and which parts to order. I needed a new control panel and chose also to replace the overlay that shows on the front of the stove. I could have reused the old one because I turned out to be able to remove it without damaging it. I just kept it in case I damage the new one in the future. The “fast” shipping (not overnight) option had the part delivered the next morning, which was a nice surprise. I felt... Read more

This was the motor control board (also called the speed control board, motor control unit, or MCU in various places across the web). The repair was straightforward, except for two complications. First the old part was difficult to access in this model washer (Frigidaire Gallery Series front load washer). Instead of being easy to reach on the left side where there was space, it was sort of behind the actual motor on the right side of the housing. I spent some time trying to figure out... Read more

We have a Frigidaire LGHS2667KE0. I’m not an appliance technician. Our refrigerator was not working. We were getting an error code SY CE on the front control panel. I tried unplugging it for about an hour and plug it back in. The refrigerator would cut off and on for about 30 seconds, shut down and beep leaving me with the same code. I called an appliance repair technician who pulled the main board from the front bottom of the refrigerator. He believed it was a relay and or the... Read more

Replaced the Control Board. (Originally purchased a remanufactured one from another website, it worked for 5 loads of clothes and the error came back!) One from AppliancePartsPros.com has been working perfectly! Read more

That code means that one of the buttons is stuck. Took it apart to investigate and determined that all buttons were working properly. Only other thing to do was replace the control board. Pretty easy job and doing it myself probably saved a couple hundred bucks. Now I'm drying clothes like a mad man! Read more

Order the part from you all. Watched the video how to install, which was easy to understand. the part arrived A DAY EARLIER than we expected! How nice is that? and installed part, stove /oven works. everybody's happy. Read more

Replaced Oven Control Board. I already had removed the old part when I ordered the replacement. Part showed up in 48 hours. It took me about two minutes to install the new part. Tested to make sure it worked, then another 30 seconds to screw the back panel of the stove on. Read more

• Timer will not advance

I replaced the timer Read more