General Electric Fuse Or Sensor

Oven not heating or overheating? The lower vent limit switch protects against excessive heat. Direct replacement part restores safe operation.

This thermal cutoff (TCO) is a temperature-sensing safety device that stops power to the heating circuit, protecting the unit from heat damage and preventing unsafe operation. It's used in heating assemblies. What it does:

• Opens the circuit when temperatures exceed safe limits to prevent overheating.
• Stops the heater or heating element from running if a fault causes excessive heat.
• Common symptom: no heat or intermittent heating when the TCO has failed.
• Can be checked for continuity with a multimeter to confirm failure.

• Disconnect power before inspecting or replacing any thermal safety device.
• Locate the TCO on the heater/air path assembly per your model's service instructions.
• Test the part for continuity before replacement to confirm it's defective.

This thermostat is the temperature control that regulates oven heat for consistent cooking results. It replaces a failed control to restore correct temperature cycling and help your range maintain set oven temperatures. What it does:

• Senses oven temperature and opens/closes the control circuit to maintain the set temperature
• Helps prevent ovens from running too hot or too cool
• Commonly replaced when oven fails to reach or hold set temperatures or cycles unusually
• Works with the oven's control system to restore normal heating cycles

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Access typically through the oven control or rear access panel; expect basic wiring and mounting steps
• Verify correct wire connections and secure mounting; test oven operation at low settings first

Fix microwave overheating, undercooking, or error codes with this temperature sensor. Monitors cooking temp for accurate heating. Moderate DIY repair.

This replacement thermal cutoff fuse helps protect ovens and ranges by opening the circuit if temperatures rise too high, preventing overheating and potential damage. Install to restore safe temperature protection and normal heating operation. What it does:

• Interrupts power when internal temperatures exceed safe limits to prevent overheating
• Stops heat element operation when the cutoff is open
• Common symptom: oven or bake element will not heat
• Can cause intermittent heating or failure of specific heating functions

• Always disconnect power at the breaker or unplug the appliance before servicing
• Allow the appliance to cool completely before touching internal components
• Handle fuse terminals carefully; replace with the exact part number to maintain safety features