General Electric Fuse Or Sensor

Dishwasher overheating or won't complete cycles? This overtemperature thermostat prevents heat damage by shutting down when temps exceed safe limits.

This ignition electrode is the oven/range spark element that provides the spark used to light the burner or bake igniter assembly. It replaces a worn or damaged electrode to restore reliable ignition. What it does:

• Conducts the high-voltage spark to the burner area so gas can ignite
• Helps stop repeated clicking or continuous sparking when broken or cracked
• Commonly replaced when a burner or oven fails to light or sparks are weak
• Works with the appliance's ignition module and gas valve to start the flame

• One ignition electrode (inside)

• Turn off electrical power and shut off the gas supply before servicing
• Handle the ceramic insulator and tip carefully to avoid damage
• Inspect wiring and connectors for corrosion; replace damaged wiring as needed

This heater thermistor is a temperature-sensing replacement part that helps the appliance monitor and regulate heating. Replacing a failed thermistor restores accurate temperature feedback for safer, more consistent operation. What it does

• Measures temperature near the heater and sends a signal to the control board.
• Helps the unit cycle heating on and off to maintain proper operating temperature.
• Common symptom: appliance won't heat or heats intermittently.
• Common symptom: cycles too frequently or shows error codes related to temperature sensing.

• One heater thermistor.

• Disconnect power before accessing or replacing the thermistor.
• Handle the sensor and connector carefully to avoid damage to the lead or plug.
• Verify connector orientation and secure wiring; do not force connectors.

Washer won't stop filling and overflows? This overflow sensor detects high water levels to prevent flooding. Common fix for washers that overfill continuously.