Housing Or Cover

Replace your washer dryer combo's damaged or cracked housing cover. This protective cover installs on the exterior to restore your appliance's appearance.

Replace your refrigerator's control housing cover if cracked, broken, or missing. This protective cover installs over the control panel assembly.

This lower interior light housing assembly replaces a cracked or damaged refrigerator lower light housing and restores the light fixture mounting and lens for proper illumination of the fresh-food compartment. What it does:

• Replaces the lower interior light housing and lens assembly to secure the light and lens in place
• Restores proper alignment and protection for the lower refrigerator light
• Helps stop rattling or movement caused by a broken housing
• Addresses symptoms like a loose or missing lens, exposed bulb, or improper light positioning

• One lower interior light housing assembly (housing with lens as shown)

• Disconnect power to the appliance before starting any repair
• Remove the existing housing carefully to avoid damaging the bulb or wiring
• Retain or reuse the original bulb unless explicitly replacing it
• Use proper fasteners and alignment tabs;

This is a freezer light module that houses the LED or bulb assembly inside the freezer compartment. It provides illumination when the freezer door is opened so you can see the contents clearly. Replace this module if the freezer light no longer turns on, flickers, or the housing is cracked or damaged.

Outer housing that protects and organizes range hood control switches and wiring. Replace if cracked, broken, or missing to secure electrical components.

Replace your refrigerator's main cabinet housing enclosure. This structural part supports internal components and maintains alignment. Ideal for cracked or damaged housings.

Ice route cover housing that installs in the freezer section. Replace if cracked, broken, or missing to restore proper ice pathway protection.

Replaces the molded cover that secures and protects your refrigerator's dispenser area. Needed when the original housing is cracked, broken, or missing.

Outer cover for refrigerator dispenser assembly. Replaces cracked, broken, or missing housing shield. Protects internal components and restores clean appearance.

Plastic cover that protects and directs airflow around the refrigerator condenser coils. Replace if cracked, broken, or missing to shield components.

Replaces cracked or missing light shield and housing in your refrigerator's fresh food compartment. Restores proper illumination and protects bulb. Verify fit.

Welded convection baffle directs airflow in wall ovens and ranges. Replace if cracked, damaged, or missing to restore proper air circulation.

Nickel-plated dome plug cap for range hood housing. Replaces cracked, missing, or worn decorative plugs. Installs on ventilation cover assembly.

This is the front control panel for a range vent hood that houses the buttons or switches for fan speed, lighting, and other ventilation settings. It mounts to the underside or front face of the hood and provides the user interface for operating the exhaust system. Replace this panel if buttons are unresponsive, the panel is cracked or damaged, or if the controls no longer properly activate the fan or lights.