Housing Or Cover

Ice not dispensing from your refrigerator? This auger motor assembly drives the mechanism that moves ice from the bin to the dispenser chute. DIY repair.

Molded duct housing that channels airflow from the dryer assembly to the outlet path. Replace if cracked, warped, or broken to restore proper sealing.

Replace your refrigerator's dispenser housing shield cover if cracked, broken, or missing. This protective cover installs over the dispenser housing.

Fix a squealing or wobbling dryer with this blower wheel housing assembly. Includes wheel, housing, and cover. DIY install in 20-30 minutes.

Mounts behind the interior light to direct and spread illumination. Replace if cracked, melted, warped, or missing to restore bright, even lighting.

Molded housing that mounts and protects the ice dispenser motor inside the freezer door. Replace if cracked, broken, or missing to secure motor alignment.

Housing cover for bottom-mount refrigerators. Replaces cracked, broken, or missing plastic housing. Installs inside refrigerator compartment.

Replacement lamp support cover for range hood light housing. Shields bulb and wiring from grease and moisture. Replaces cracked, broken, or missing covers.

Molded cabinet housing for refrigerator air handler assembly. Replace if cracked, broken, or damaged to restore proper structural support and airflow.

Guides dryer airflow from drum to lint screen housing. Replace if cracked, broken, or missing to restore proper air path and contain lint in ductwork.

Protective cover that slips over the gas valve shaft to shield valve components from spills, food debris, and moisture. Replace if cracked or missing.

This is the blower housing that encloses the dryer blower wheel in a washer/dryer combo or laundry center unit. It directs airflow from the dryer drum through the exhaust system to properly vent heat and moisture. Replace this housing if it is cracked, warped, or damaged, which can cause poor drying performance, unusual noises, or air leaks during the drying cycle.

Houses and protects your refrigerator's electronic control board components. Replace if the housing is cracked, broken, or damaged to restore secure mounting.

Rear panel that shields your range's internal wiring and components. Replace if cracked, damaged, or missing to protect electronics from dust and heat.

Outer stainless trim piece that fits around the refrigerator dispenser. Replace if cracked, dented, or worn to restore the finished appearance.

Replace a cracked, chipped, or missing microwave turntable plate. This glass dish installs on the drive roller to restore the rotating cooking surface.