Support Parts

Secures the fold-down tine row on your dishwasher rack. Replace this retainer if it's worn, broken, or missing to restore smooth pivoting and stability.

Secures the fan housing to its mounting points. Replace if the clip is broken, missing, or worn to eliminate rattles and prevent air leaks in your dryer.

Spider arm connects the wash basket to the drive shaft in front-load washers. Replace if cracked, corroded, or broken to restore proper basket support.

Supports and centers the inner tub in front-load washers. Replace if cracked, corroded, or broken to restore proper drum alignment and balance.

Replaces the refrigerator's outer front plate when cracked, dented, rusted, or worn. Restores finished appearance and covers internal components.

Replacement support plate for microwaves. Restores secure mounting and fit when original is bent, cracked, or missing. Stops rattles and misalignment.

Trunnion assembly for washing machines. Supports and allows outer tub rotation during wash and spin cycles. Replace if cracked, worn, or damaged.

Metal mounting bracket that secures internal components in your trash compactor. Replace if bent, damaged, or missing to restore stable part alignment.

Replacement holder for your dishwasher. This support component secures internal parts in place. Order a new holder if yours is broken, cracked, or damaged.

This Support (mounting bracket) secures internal components and stabilizes the appliance's assembly to help prevent sagging, misalignment and excess vibration. It's a small replacement that restores proper fit and reduces rattling. What it does:

• Provides a stable mounting point for panels or internal assemblies
• Keeps components aligned to prevent binding or wear
• Reduces noise caused by loose or sagging parts
• Helps stop intermittent contact or rubbing that can cause rattles

• Disconnect power (and water, if applicable) before servicing
• Access may require removing outer panels or trim; keep track of fasteners
• Support the assembly while replacing the bracket to avoid strain

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

Mounting plate that secures and aligns dishwasher components. Replace if cracked, broken, or missing to restore proper fit and prevent rattling.

Molded plastic mounting bracket that secures and stabilizes refrigerator components. Replaces broken, cracked, or missing brackets to keep parts aligned.

Door strike plate for trash compactors. Mounts to cabinet frame to secure the door latch. Replace if cracked, bent, or missing to restore proper closure.

Holds and secures lava rocks on gas range burner assemblies for even heat distribution. Replaces cracked, broken, or missing basket. Installs above burner.

Mounting bracket that secures the control assembly in your laundry center. Replace if cracked, broken, or worn to restore proper panel alignment.