Support Parts

Replaced all leaky parts including the wash arm that send water to the top rack. Most parts are just snap-in and one required a single screw. Very easy job. Read more

I was able to purchase all needed parts through Appliance Parts Pros. It was an easy fix, and only took about 10 minutes. Read more

We ordered the bracket and were able to save the client money by not having to buy Read more

Replaced all 4 shocks, and 2 suspension springs. The overall fix was easy for the shocks which only require a quarter turn with a cresent wrench to replace. The suspension springs are more difficult because the bottom of the washer drum must be supported due to the substantial weight. I used a car jack to support the drum from the bottom and a long bunge wrapped around the main drive pulley. I.would not have been able to do this as a one person without it. While replacing the suspension parts,... Read more

We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more

Ordered tracks and adjusters via chat. Adjusters were not needed so I returned them. The repair was very easy. Had to slide out the dishwasher and remove four screws holding each track. Installed new tracks and put dishwasher back in place. Read more

Bought these two pieces through Appliance Parts Pro - they matched exactly at half the cost. Shipped same day. Read more

Replaced pump and motor part. Read more

• Not cleaning dishes properly

Ordered parts from appliance pro and installed was a easy repair saved service call no tolls was neede Read more

Replaced it with an original part. Read more

Ordered this conduit tiered blast asm and was able to detach and reattach in less than 5 minutes. Read more

Replaced transmission and support assembly. Hub nut corrode on support, spanner wrench would not loosen. Had to use 1 11/16 deep socket and impact wrench to remove, basket would not com off support even after cleaning out and soaking with penetrant and using automotive air hammer to push out. I had to cut support plate in half with die grinder, cut bearing from shaft and punch out agitator shaft then use die grinder with carbide burr to cut basket shaft in two before basket would come off... Read more

Looked at schematic on AppliancePartsPros.com. Checked power, power filter, next component in line was the thermostat, found thermostat with signs of overheating, thermostat was open, replaced the thermostat, micro works perfect. Took longer to get it out than diagnose it. Read more