Washer Control Board

Fix a washer that won't start, stops mid-cycle, or shows error codes with this main control board. Moderately difficult repair requiring basic tools.

Fix a washer that won't advance cycles or stops mid-cycle with a timer control replacement. Restores automatic cycle progression and proper timing.

Fix a washer that won't advance through cycles or stops mid-cycle with this timer. Controls wash, rinse, and spin sequences. Moderate DIY repair.

Fix washer display issues, cycle problems, or unresponsive buttons with this electronic control board. Direct replacement restores full functionality.

This power control board is the appliance's main electronic PCB. It manages power distribution and control logic, coordinating sensors and user inputs so the unit's motors, fans, heaters, and valves run when they should. What it does:

• Distributes and regulates power to key components through onboard relays
• Processes sensor feedback and timing to execute programmed operations
• Coordinates operation of motors, fans, heaters, and valves as required
• Common failure symptoms: unit won't power on or start, unresponsive controls/display, intermittent or erratic operation, repeated clicking from the control area, or error codes

• 1 electronic control board assembly

• Disconnect power before servicing; verify power is off
• Use ESD protection and handle the board by the edges
• Photograph/label connectors and transfer plugs one at a time, ensuring proper seating and orientation
• Secure the board, reassemble covers, restore power, and verify normal operation

Washer stuck between cycles or skipping rinse? This timer controls cycle sequence and duration. DIY repair typically takes 10-15 minutes with basic tools.

Washer won't advance through cycles or gets stuck? Timer controls wash cycle progression. Quick DIY repair—remove lid, unplug harnesses, swap timer.

This is the main electronic control board that manages all washer functions, including cycle selection, water fill, motor operation, and spin speed. It is typically mounted inside the control panel or rear of the machine and connects to the various components via wire harnesses. Replace this board if the washer fails to start, stops mid-cycle, displays error codes, or if buttons and cycle selections are unresponsive.

Fix washer display issues, water level problems, or cycle failures with this electronic control board. Manages wash cycles and system functions.

Fix error codes, blank displays, or cycle problems with this washer electronic control board. Restores proper operation when buttons don't respond.

Washer won't start or stops mid-cycle? Flashing lights or unresponsive controls? This control board assembly restores function. 10-minute DIY repair.

Fix washer beeping, stopping mid-cycle, or not spinning with this control board. Moderately difficult repair requiring console disassembly and careful handling.

Fixes washer that won't start, complete cycles, or respond to controls. This main control board restores electronic functions and display communication.

Fix a washer that won't advance through cycles or gets stuck during wash. This timer assembly controls fill, agitate, drain, and spin sequencing.

Washer won't spin or start? This control board assembly manages cycle functions and restores normal operation. Mounts below the control panel.

Fix a washer that won't start, pauses mid-cycle, or has unresponsive buttons. This electronic control board restores normal operation and cycle timing.