Cap Or Cover

Covers and protects the air diffuser opening in your refrigerator. Replace if cracked, broken, or missing to restore proper airflow direction and sealing.

Replacement outer trim cover for refrigerators. Restores exterior appearance and protects internal components. Installs where original is cracked or missing.

Replacement bowl cover for food processor work bowl opening. Restores protective surface if original cover is cracked, broken, or missing. Direct fit.

This is a panel that covers the compressor compartment, typically located at the bottom rear of the refrigerator. It protects the compressor, condenser coils, and related components from dust and debris while allowing access for maintenance. Replace this cover if it is cracked, broken, or missing to keep the compressor area properly enclosed and protected.

Rear housing panel that shields internal components and maintains airflow. Replace this outer cover if cracked, broken, or missing to restore protection.

Plastic cover that conceals the top hinge assembly on your refrigerator. Replace if cracked, broken, or missing to restore a clean appearance.

Protective cover for evaporator tubing in the freezer compartment. Replace if cracked, broken, or missing to prevent tube damage and maintain airflow.

Replacement lid for washer bleach dispenser compartment. Keeps bleach contained during fill cycle and prevents spills. Order if cracked, missing, or broken.

Black plastic hinge cover cap for side-by-side refrigerators. Replaces cracked, broken, or missing hinge covers that expose internal hardware.

Replacement blender lid with removable center insert. Seals the blender top to contain ingredients during blending. Needed when original is cracked or missing.

Refrigerator hinge cover cap that protects and conceals hinge hardware. Replace this plastic cap if yours is cracked, broken, or missing for a complete look.

Replace your washer's cracked or missing access cover. Restores exterior protection, shields internal components from dust and moisture, and provides a clean finished appearance.

Protective cover for the cutting grid assembly in ice makers. Replace if cracked, broken, or missing to shield cutting blades and maintain proper alignment.

This replacement cover is an access panel that restores the appliance's exterior finish and protects internal components from dust and debris. It fits into the original mounting points and matches the OEM shape for a clean, factory appearance. What it does:

• Shields internal components and wiring from dirt and accidental contact
• Restores a uniform exterior surface for proper airflow and appearance
• Helps prevent small objects from entering service areas that could cause issues
• Suitable when the original cover is cracked, warped, or missing

• One replacement cover as shown

• Use basic hand tools to remove fasteners and lift off the old cover before installing the new one
• Align mounting tabs and secure with original screws; do not overtighten to avoid cracking the plastic
• Disconnect power at the breaker or unplug the appliance before servicing to avoid shock or injury
• Replace damaged mounting hardware before completing installation

Protective cover that shields the manifold assembly from dust and debris. Replace if cracked, broken, or missing to restore a secure, finished look.

Covers and protects the upper door hinge area on your refrigerator. Replace if cracked, broken, or missing to restore a finished look.